Table of Contents
Available languages
Available languages
BM 2610025580 05-13_BM CM8S 5/17/13 1:37 PM Page 15
WARNING
source
before
adjustments or repairs.
Head Assembly lock pin
The head assembly lock pin (figure 8) is used to hold
the saw's head assembly in the DOWN position. This
position prevents the head from bouncing up and
down during transportation. This also makes the saw
more compact for lifting and storage. This position is
also required for some calibrating procedures.
To Engage the Head Assembly lock pin:
1. Check that the depth stop plate is disengaged,
pressed in against saw head, (figure 9).
2. Grasp the saw's main handle and press down on
the head assembly.
3. While pressing the saw head down, push in on the
head assembly lock pin, (figure 8). Release the
head assembly. The head will be locked in the
DOWN position.
To Disengage the Head Assembly lock pin:
1. Grasp the main handle and press down on the
head assembly.
2. While pressing the head down, pull out the head
assembly lock pin. Release the lock pin, but
maintain your grip on the main handle. Slowly
allow the spring-loaded saw head to come up to
the top of its travel and then release the handle.
Adjustments
Using the Head Assembly lock pin
To
avoid
possible
disconnect plug from power
performing
any
assembly,
injury,
FIG. 9
Depth
Stop plate
15.
FIG. 8
Head
Assembly
lock pin
- Quick Links:
- Removing and Installing Blades
Hide quick links:
Chapters
Table of Contents
Troubleshooting
