Specifications - Philips FW-M355 Service Manual

Mini system
Hide thumbs Also See for FW-M355:
Table of Contents

SPECIFICATIONS

GENERAL:
Mains voltage : 110-127V/220-240V Switchable for /21M
220-230V for /22/34
120V for /37
Mains frequency
: 50/60Hz
Power consumption : < 80W Active
< 15W at Standby with Clock on
< 0.5W at ECO Standby /22
Clock accuracy
: < 4 seconds per day
Dimension centre unit : 265 x 310 x 365mm
TUNER:
FM
Tuning range
Grid
IF frequency
Aerial input
Sensitivity at 26dB S/N
Selectivity at 600kHz bandwidth
IF rejection
Image rejection
Distortion at RF=1mV, dev. 75kHz
-3dB Limiting point
Crosstalk at RF=1mV, dev. 40kHz
MW
Tuning range
Grid
IF frequency
Aerial input
Sensitivity at 26dB S/N
Selectivity at 18kHz bandwidth
IF rejection
Image rejection
Distortion at RF=50mV, m=80%
AMPLIFIER:
Output power
Frequency response within -3dB
Dynamic Bass Boost
: DBB ON, DBB 1, DBB 2, DBB 3
Digital Sound Control
: Jazz, Techno, Optimal, Rock
Headphone output, R
= 32Ω
LOAD
Input sensitivity, R
= 600Ω
S
Aux / CDR : 500mV / 1.0V
: 87.5-108MHz
65.81-74MHz for /34
1)
: 50kHz (& 30kHz for /34)
100kHz for /21M/37
: 10.7MHz ± 20kHz
: 75Ω coaxial
: < 7µV
: > 25dB
: > 60dB [80dB]
: > 25dB [75dB]
: < 3%
: < 8µV
: > 18dB
: 531-1602kHz
530-1700kHz for /21M/37
: 9kHz
10kHz for /21M/37
: 450kHz ± 1kHz
: Frame aerial
: < 4.4mV/M [4.0mV/M]
: > 18dB
: > 45dB
: > 28dB
: < 5%
: 2 x 40W RMS
2)
2 x 33W FTC
3)
: 50Hz-15kHz
4)
: 15mW ± 2dB
Mic : {3.5mV}
1-3
CASSETTE RECORDER:
Number of track
Tape speed
Wow and flutter
Fast-wind/rewind time C60
Bias system
Rec/Pb frequency response within 8dB
Signal to noise ratio
VCD/COMPACT DISC:
Audio Performance:
Measurement done at output conn. of the 3CDC module.
Frequency response within ± 3dB : 20Hz - 20kHz
Output level (in Vrms)
Signal/Noise ratio (A-weighted)
Distortion at 1kHz
Channel unbalance at 1kHz
Channel separation at 1kHz
De-emphasis
MPEG 1 Layer 3 (MP3-CD)
MP3-CD bit rate
MP3-CD sampling frequencies
Recording Format
Video Performance (for VCD version only) :
Video output level
Luminance non-linear distortion
Luminance S/N ratio
{....} Values for /21/21M only
[....]
Values for Cenelec Tuner version only
Default setting is OFF, to switch on please refer page 3-1.
1)
6Ω, 1kHz, 10% THD
2)
6Ω, 60-12500Hz, 10% THD
3)
Frequency response in each setting is software controlled.
4)
4)
: 2 x 2 stereo
: 4.76 cm/sec +2.5/-1.5%
: < 0.4% DIN
: 130 sec
: 78kHz ± 10kHz
: 80Hz - 12.5kHz
Type I : > 48dBA
: 500mV ± 1.5dB, R
: > 80dBA
: < 0.003%
: ±1dB
: > 60dB
: 0 or 15/50 mS (Switched by subcode
on the disc)
: MPEG AUDIO
: 56-256 kbps
: 32kHz, 44.1kHz,
48kHz
: ISO 9660
UDF format not supported.
: 1.0V ± 0.2V
: < 0 ± 5%
: > 50dB
= 100Ω
out
Table of Contents
loading

Table of Contents