TROUBLESHOOTING
Before taking the camera for repairs, please check below to make
sure that the camera is used correctly. If it still does not perform
correctly, please consult your dealer or a Sanyo Authorized Service
Center.
No picture on the monitor screen
•
Is the power turned on to all connected devices? Is the voltage
correct?
•
Are all the signal connecting cables correctly connected?
•
Is the lighting sufficient?
The picture is not clear
•
Is the monitor correctly adjusted?
•
Is the lens focus correctly adjusted?
•
Are the lens surfaces clean?
If there is dust or finger prints on the lens, the image quality will
deteriorate. To clean the lens use a soft cloth or a commercially
available lens cleaning set.
SERVICE:
This camera is a precision instruments and, if treated with care, it
will provide years of satisfactory performance. However, in the
event of a problem, the owner is advised not to attempt to make
repairs or open the cabinet. Servicing should always be referred to
your dealer or Sanyo Authorized Service Center.
9
English
SPECIFICATIONS
Camera
TV system
Scanning system
Image device
Picture elements
Effective picture elements
Synchronization system
Resolution
Video output signal level
S/N ratio
Minimum required
illumination
Electronic iris range
Iris system
Gain control
Lens
Angle of view
CCIR standard (625 TV lines, 25
frames/sec.)
625 TV lines, 50 field/sec.,
2:1 interlace
Interline transfer method, 1/3 inch
solid state CCD
537 (H) × 597 (V)
500 (H) × 582 (V)
Internal sync.
400 TV lines horizontally, 400 TV
lines vertically
1.0 Vp-p/75Ω (screw-on terminal)
More than 50 dB
0 lux
1/50 to 1/80,000 sec.
Electronic iris
Automatic
Built-in, F2.0, f=3.8 mm, fixed focal
lens, focus adjustment
Horizontally: Approx. 71˚
Vertically: Approx. 53˚
Diagonal: Approx. 90˚
