Carburettor Adjustment - Husqvarna 435 Workshop Manual
Hide thumbs
Also See for 435:
- Operator's manual (120 pages) ,
- Operation manual (44 pages) ,
- Operator's manual (44 pages)
Table of Contents
Carburettor adjustment
Conditions during adjustment
•
The air filter should be clean and the cylinder
cover fitted when adjustments are made. Ad-
justing the carburettor with a dirty air filter will
give a too lean fuel mixture the next time the
air filter is cleaned. This can result in serious
damage to the engine.
•
Mount, for this model, approved bar and
chain combination (see Technical data in the
Operator's Manual).
435/e
16"
440e
16"
•
The chain should not be tensioned more than
that it remains ~ 0,2 inches to the bar.
(See figure 43)
Replacement of the H-needle or complete car-
burettor
1. Carefully screw the new H-needle to the bot-
tom and turn it anticlockwise "A" turns.
435/e
A = 2
440e
A = 2
2. Start the engine. If necessary, adjust the idling
speed with the T-screw until the chain stops.
3. Adjust the H-needle to give a top speed of "B"
rpm. Use a tachometer.
435/e
B = 12500 -13 000, speed limitation
440e
B = 12500-13 000, speed limitation
Use screwdriver 530 03 55-60.
4. Let the engine run at "B" rpm ~ 1 minute, until
warm.
Replacement of the L-needle
1.
Screw the new L-needle to the bottom and
then turn it counterclockwise "D" turns.
435/e
D = 2,5
440e
D = 2,5
(See figure 44)
Fig 43
Fig 44
Repair instructions
41
English –
Hide quick links:
Chapters
Table of Contents
Troubleshooting
