Table of Contents
the liquid off using a cloth. Avoid skin
contact.
In case of skin or eye contact, follow
the instructions below.
Warning! The battery fluid may cause
personal injury or damage to property. In
case of skin contact, immediately rinse
with water. If redness, pain or irritation
occurs seek medical attention. In case of
eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
Use your Black & Decker charger
only to charge the battery in the
appliance/tool with which it was
supplied. Other batteries could burst,
causing personal injury and damage.
Never attempt to charge non-
rechargeable batteries.
If the supply cord is damaged, it must
be replaced by the manufacturer or
an authorised Black & Decker
Service Centre in order to avoid a
hazard.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The appliance/tool/battery must be
placed in a well ventilated area when
charging.
Safety of others
This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning the use of the appliance
by a person responsible for their
safety.
Children should be supervised to
ensure that they do not play with the
appliance.
Electrical safety
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate. Never attempt to
replace the charger unit with a regular
mains plug.
Symbols on the charger
Your charger is double
insulated; therefore no earth
wire is required.
Short circuit proof safety
isolating transformer. The mains
supply is electrically separated
from the transformer output.
The charger automatically shuts
T1A/250 Vac
off if the ambient temperature
becomes too high. As a
consequence the charger will be
inoperable. The charging base
must be disconnected from the
mains supply and taken to an
authorised service centre for
repair.
Charge only at ambient
ta = 40°C
temperatures between 10°C and
40°C
The charging base is intended
for indoor use only.
Features
1. Dust collector extension
2. Dust collector
3. Release button
4. On/Off switch
5. Charging indicator
6. Filter cleaning button
7. Charging base
Fig. A
8. Crevice tool
9. Brush tool
7
- Quick Links:
- Intended Use
- Instruction Manual
Hide quick links:
Table of Contents
