Table of Contents
SP6471-1 HD1205.1211 - 71157
Troubleshooting
TROUBLE
Unit will not run and
• No power
Fill Light is not illu-
• Selected humidity level has
minated.
Unit will not shut off
• Float is not free
• Float retainer positioned in top
Unit will not dry out
• This is normal
completely
Slow Evaporation
• Dirty filters
of Water
Water runs out of
• Too much water added
rear of unit
• Water splashing during filling
CAUTION: Use only EPA Registered Bacteriostat available from your local
retail store.
Use of other water treatment products may damage the filter elements.
Under no circumstances should you use water treatment products designed
for Roto belt Ultrasonic humidifiers.
FOR TECHNICAL HELP
If in the USA call 1-800-654-3545
If in Canada call 1-888-744-4687
7/12/05
2:08 PM
PROBABLE CAUSE
been established
slot at back of cabinet
13
Page 13
REMEDY
• Check 120 volt source for power
• Raise humidistat setting if desired
• Free float from obstruction
• Slide float retainer down to lowest
position in slot at back of cabinet.
(See diagram on page 11)
• A small amount of water will
remain in cabinet after fill light
comes on. To completely dry out
cabinet see "Manual Dryout" sec-
tion on page 7.
• Change to fresh new filters.
Purchase Emerson HDC411
Replacement Filters.
• Do not overfill past "Full" labels in
cabinet
• Deflect fill water off of the splash
guard.
Hide quick links:
Table of Contents
