Reading The Battery/Charge Status Led Indicator; Charging/Recharging The Spotlight - Black & Decker Waterproof 3W LED Spotlight Instruction Manual

Waterproof 3w led spotlight
Table of Contents
Available languages

Available languages

controls and Functions
6
5
4
3
1
  1. Rubber "O" ring
  2. Translucent  waterproof  end  cap  (see  detailed 
view on page 5)
  3. 12 volt DC charging port (for use with 120 
volt AC charger and 12 volt DC charger)
  4. Battery/charge status LED indicator
  5. Rubber bezel

reADiNg the BAtterY/chArge stAtUs leD iNDicAtor

The battery and charging status LED indicator is located directly above the 12 volt DC charging port 
under the waterproof end cap on the back of the unit. 
END CAP DETAIL
7
8
9
2
10
  6. 3 watt LED bulb
  7. Dimmer selector knob
  8. On/off power knob
  9. Grip handle
10. 120 volt AC charger
11. 12 volt DC charger (optional accessory)
DOT ICON (FOR 
ALIGNMENT TO 
THE TRIANGULAR 
ICON ON THE 
END CAP)
TRIANGULAR 
ARROW 
ICON (FOR 
ALIGNMENT 
TO THE DOT 
ICON ON THE 
REAR OF UNIT)
It lights or flashes in three colors to indicate the following:
When charging:
Green & Red (flashing alternately): Battery is overheated due to extensive use or recharging. The 
charging process will stop at this stage and will automatically resume after a cool down period of 
several minutes.
Green: Battery is in a fully charged state.
Orange: Battery is in a partially charged state.
Red: Battery needs to be recharged.
When operating:
Green: Battery is operating at full voltage.
Orange: Battery is operating at partial voltage.
Red: Battery is operating at low voltage, and should be recharged.
Red (flashing): Battery is operating at extremely low voltage. The built-in low voltage protection has 
activated and the unit will automatically shut down (after sounding several "beeps"). The unit must be 
recharged immediately.
When using the dimmer selector:
Green (flashing): The light is adjusting to dimmer setting.
Red (flashing): The light is adjusting to brighter setting.

chArgiNg/rechArgiNg the sPotlight

This unit is shipped in a partially charged state. Charge unit after purchase and BEFORE first use using 
either the 120 volt AC charger or the optional 12 volt DC charger for approximately 3-5 hours. Charge 
after each use until the battery/charge status LED indicator lights green.
11
IMPORTANT: When the unit is not in use, we recommend that the battery is charged at least every
30 days.
CAUTION: TO REDUCE THE RISK OF PROPERTY DAMAGE:
• Make sure the unit is thoroughly dry before charging or recharging. If the unit has been submerged, 
wipe it dry with a soft cloth before opening the end cap.  If water leaks into the charging port, the 
unit can sustain permanent damage.
charging/recharging using the 120 volt Ac charger
• Make sure the spotlight is turned off by rotating the on/off power knob to the furthest position 
clockwise.
• Unscrew (counterclockwise) the waterproof end cap on the back of the unit and remove it.
• Insert the barrel connector of the AC charger into the 12 volt DC charging port on the back of the 
unit. Insert the plug end into a (powered) standard North American 120 volt 60Hz outlet.
• Charge until the battery/charge status LED indicator lights green (approximately 3-5 hours).
• Replace the end cap on the unit, screwing clockwise until the triangular arrow on the end cap is 
pointing to the dot icon on the rear of unit. Make sure it fits securely, but do NOT overtighten.
charging/recharging using the 12 volt Dc charger (optional accessory)
• Make sure the spotlight is turned off by rotating the on/off power knob to the furthest position 
clockwise.
• Unscrew (counterclockwise) the waterproof end cap on the back of the unit and remove it.
• Plug the barrel tip of the supplied 12 volt DC charger into the 12 volt DC charging port.
• Insert the 12 volt DC plug end into the accessory outlet of your vehicle or other 12 volt DC power 
source.
• Charge until the green battery status LED lights (approximately 3-5 hours). DO NOT CHARGE FOR 
LONGER THAN 5 HOURS USING THIS METHOD.
• Replace the end cap on the unit, screwing clockwise until the triangular arrow on the end cap is 
pointing to the dot icon on the rear of unit. Make sure it fits securely, but do NOT overtighten.
Note:
When using a vehicle' s 12 volt DC accessory outlet as a charging source, be aware that some vehicles require you to turn on the
ignition to power the accessory outlet.
IMPORTANT NOTES:
• If either of the chargers is plugged into the spotlight while it is operating, the unit will not charge. 
The unit will begin charging once the spotlight is turned off.
• If either of the chargers is plugged into the spotlight while the built-in low voltage protection is 
activated, the unit will automatically turn off and begin charging.
Table of Contents
loading

This manual is also suitable for:

Fl3wbd

Table of Contents