Table of Contents
5. DISASSEMBLY AND REASSEMBLY
The ice maker is located inside of the ice dispenser
assembly.
1. Remove ice maker support screws (2), and slide out.
2. Disconnect the ice maker wire connector.
3. Unlock the locking tabs to separate the ice maker kit.
In order to assemble the icemaker kit.
1. Assemble the geared motor shaft and the front of
ice tray.
2. Lift the front locking tab and assemble the ice
maker kit.
3. Connect the ice maker wire connector.
4. Match the tab holes and tabs(2) located on the
top of the liner, and slide the ice maker in.
5. Tighten the screws (2) of the ice maker support.
Auger Motor Case
This shelf is designed to support the ice maker
ice dispensed and Xtra Space
1. Remove the Xtra Space
and pull front.
2. Slide the partition out.
3. Remove the screws (2) on the bottom front of the
case.
4. Slide out the case while disconnecting the wire
connect.
47
TM
.
TM
cover to push it down
Partition
Screws
- Quick Links:
- 3-1) Digital Panel
Hide quick links:
Chapters
Table of Contents
Troubleshooting
