Daikin C-Series Service Manual page 41
Inverter pair duct connected type c-series
Hide thumbs
Also See for C-Series:
- Installation manual (104 pages) ,
- Operation manual (27 pages) ,
- Technical manual (73 pages)
Table of Contents
SiBE07-618_C
2. Determine upper limit frequency
3. Determine lower limit frequency
4. Determine prohibited frequency
Indoor Frequency Command ( ∆ D signal)
The difference between the room thermistor temperature and the target temperature is taken as
the " ∆ D signal" and is used for frequency command.
difference (°C)
∗
Th OFF = Thermostat OFF
Frequency Initial Setting
When starting the compressor, the frequency is initialized according to the ∆ D value and the Q
value of the indoor unit.
Q value: Indoor unit output determined from indoor unit volume, airflow rate and other factors.
PI Control (Determine Frequency Up / Down by ∆ D Signal)
1. P control
2. I control
3. Frequency management when other controls are functioning
4. Upper and lower limit of frequency by PI control
Function and Control
The minimum value is set as an upper limit frequency among the frequency upper limits of
the following functions:
Compressor protection, input current, discharge pipe temperature, heating peak-cut, freeze-
up protection, defrost.
The maximum value is set as an lower limit frequency among the frequency lower limits of
the following functions:
Four way valve operation compensation, draft prevention, pressure difference upkeep.
There is a certain prohibited frequency such as a power supply frequency.
∆D
Temperature
Temperature
signal
difference (°C)
∗Th
–2.0
OFF
–1.5
1
–1.0
2
–0.5
3
The ∆ D value is calculated in each sampling time (20 seconds), and the frequency is
adjusted according to its difference from the frequency previously calculated.
If the operating frequency does not change for more than a certain fixed time, the frequency
is adjusted according to the ∆ D value.
When the ∆ D value is small, the frequency is lowered.
When the ∆ D value is large, the frequency is increased.
When frequency is drooping;
Frequency management is carried out only when the frequency droops.
For limiting lower limit
Frequency management is carried out only when the frequency rises.
The frequency upper and lower limits are set according to the command on indoor unit.
When the indoor or outdoor unit quiet operation command comes from the indoor unit, the
upper limit frequency is lowered than the usual setting.
∆D
Temperature
signal
difference (°C)
0
4
2.0
0.5
5
2.5
1.0
6
3.0
1.5
7
3.5
Control Specification
∆D
∆D
Temperature
signal
difference (°C)
signal
8
4.0
9
4.5
A
5.0
B
5.5
C
D
E
F
31
Hide quick links:
Table of Contents
Troubleshooting
