Table of Contents
Installing (Optional) End Panel
Figure 71: Piping Stub-Up Details, 6" End Panel
Piping Stub-up Within Cabinet
Unit End Compartment
Wall Line 11½
1
Note: Space available in left end
compartment for piping stub-up.
Stub-up, including unions and shutoff
valves, must disconnect below floor
line for unit installation and removal.
End Panel Assembly
Accessory end panels are shipped separately with hardware and
kickplate.
The final step of unit installation is attaching the end panels. End panels
are required unless the unit has adjoining matching cabinets.
1. Refer to Figure 72 for a 1" thick end panel. Attach two (2) Tinnerman
nuts to the top edge of the end panel and two (2) to the bottom
end of the unit. Align the end panel with the front and top edges
of the unit. Insert through upper mounting holes inside unit end
compartment and thread into tinnerman clips on the end panel.
Attach the end panel to the unit using four (4) 5/32" hex socket
head fasteners provided.
Figure 72: 1" End Panel
21⅞" Unit
Projection
1/4"- 20 Tinnerman Nut, Clip
over Lower Hole in Unit Base
Page 38 of 42
Piping Stub-up Within 6" End Panel
Unit End Compartment
1
Wall Line
10¾
Left End
Space available at left end of unit
of unit
for piping stub-up when 6" end
(Less end panel)
panel is used.
1/4"- 20 × 1/2" Screw
Tinnerman Nut,
Clip on End Panel
1/4"- 20 × 1/2"
Screw
Steel Kickplate
Self-Contained WSHP Unit Ventilator Models ARQ, ERQ, GRQ
4
Left End of unit
(Less end panel)
2. Refer to Figure 73 for 6" thick end panel.
a. Position bracket (YC1934) on wall so angle is 5" from
end of unit and near bottom.
b. Mark and drill required hole for device to fasten bracket
to wall (not included).
c. Attach the bracket to wall.
d. Attach two (2) Tinnerman nuts to the top edge of the end panel
and one (1) to the bottom front of the end frame.
e. Align the end panel with the front and top edges of the unit.
Attach end panel to the unit using three (3) 5/32 " hex socket
head fasteners provided. Bracket should prevent movement of
panel toward the unit when pressure is applied to the end panel.
Figure 73: 6" End Panel with Provided Hardware
21⅞" Unit
Projection
1"
End
Panel
1/4"- 20 Tinnerman
Nut, Clip over Lower
Hole in Unit Corner
Bracket
End Panel 6"
Application and Dimension
6
All dimensions in inches
5¼" Adapter Back Painted Top (Option)
1/4"- 20 × 1/2" Screw & 1/4" Flat Washer
Tinnerman Nut,
Clip on End Panel
Oxford Brown Kickplate, Factory Assembled
to Base of End Panel
Angle Bracket
Welded for
Rigidity
5"
Bracket
YC1934
6" End Panel
IM 1083
- Quick Links:
- Data Plate - Specific Information
Hide quick links:
Table of Contents
