Related Manuals for Electrolux AW 445
Summary of Contents for Electrolux AW 445
- Page 1 MANUAL S31E47UKIN(1)99-01 Operating instruction AW 445 AW 445 T AW 455 T AW 465 AW 475 Nilfisk-Advance Italia S.p.A Località Novella Terza 26862 Guardamiglio (Lodi) Italia Tel. +39 0377 451124 Fax +39 0377 51443...
-
Page 2: Table Of Contents
INDEX SAFETY FEATURES The multifunction display on the control panel can show some code numbers when the safety devices of the machine are operated. The list of the safety code numbers is shown below: SAFETY CODE-EVENT MACHINE BEHAVIOUR POSSIBLE INTERVENTION NOTES BEFORE REPLACING THE POWER ELECTRONIC BOARD: 302:... -
Page 3: Introduction And Warnings
- The machine does not cause any harmful vibrations. MODIFICATIONS AND IMPROVEMENTS Electrolux Euroclean aim toward continuous improvement of its machines and reserves the right to carry out modifications and improvements whenever necessary without being obliged to update machines which have been sold previously. -
Page 4: Unpacking
UNPACKING OPTIONALS Check that you have received the following parts together with the machine: For models AW445 , AW445 T and AW455 T : Kit of cables to transform the machine from mains 1 - Connecting hose for squeegee version to battery operated version. Mains unit (or transformer) to change the machine from the battery operated version to the mains version. -
Page 5: Technical Specification
OPTIONALS TECHNICAL SPECIFICATION In addition to the normal accessories supplied with the machine the following optionals are available: AW 445 AW 445 AW 445 T AW 445 T MODELS Batteries: BATTERY CABLE BATTERY CABLE - For models AW465 and AW475: four 6 V... - Page 6 TECHNICAL SPECIFICATION MAINTENANCE Regularly inspect the squeegee for damage or wear to the lips. The lips may be easily replaced by unscrewing the retaining strips; remove the lips, replace with the new ones then screw the AW 455 T AW 455 T MODELS cover strips back again to retain them.
- Page 7 MAINTENANCE TECHNICAL SPECIFICATION MODELS AW 465 AW 475 Periodically remove the filter inside the dirty water Voltage tank, scrub it with a stiff brush under running Drive motor 24V-200W 24V-200W water to remove any accumulated foreign matter. Vacuum motor rating 540W-3 stages 540W-3 stages Vacuum depression (mm H2O)
-
Page 8: Machine Controls And Monitors
MACHINE CONTROLS AND MONITORS MAINTENANCE BEFORE ANY MAINTENANCE IS CARRIED OUT THE BATTERY MUST BE UNPLUGGED, OR THE MAINS LEAD UNPLUGGED. Periodically remove the filter inside the scrubbing detergent tank; scrub it with a stiff brush under running water to remove any accumulated foreign matter. -
Page 9: Preparation For Use
CLEANING OR REPLACING THE BRUSHES PREPARATION FOR USE To replace the brushes (or to clean them) carry out Partially unscrew the two middle levers on the the following sequence of operations: squeegee. Push the squeegee into the locating lugs as illustrated and fully tighten the hand-levers. The machine must be switched on but all functions (Pull the lever up to disingage it and make its switched off;... -
Page 10: Scrubbing And Drying Operation
PREPARATION FOR USE SCRUBBING AND DRYING OPERATION For models working with batteries follow the instructions below, whereas in the case of mains operated models the transformer (or mains unit) has already been placed inside the machine and needs no further installation. The batteries are supplied without liquid, therefore they must be filled up with the appropriate acid Remove the cap from the hose unscrewing the... - Page 11 SCRUBBING AND DRYING OPERATION PREPARATION FOR USE After filling the batteries must stand for at least 1 Also the tilting of the squeegee can be adjusted by means of the dedicated knob, in order to hour and then they must be filled up if necessary. After one further hour the batteries must be improve the drying capability of the machine.
- Page 12 PREPARATION FOR USE SCRUBBING AND DRYING OPERATION Drive the machine forward by holding the hand- grips, then rolling the thumb wheels forward until the machine moves. In the event of a temporary stop (releasing thumb wheels) the automatic switch-off of the all functions For models equipped with parking brake: press will occur (AUTOPOWER-OFF).
- Page 13 SCRUBBING AND DRYING OPERATION PREPARATION FOR USE In order to achieve a further reduction of the Drive the machine forward by holding the hand- water flow the water pump can also be switched grips, then rolling the thumb wheels forward until off by means of push button C.
- Page 14 Too strong a mix wastes detergent, too weak a mix will not work efficiently. NOTE: For all the versions of models AW445, AW 445 T and AW455 T the membrane and The machine is now ready for use; so move off to the water pump are optional items.