Table of Contents
36
Interval Timer Indicator
Recording
Time Indicator
Tally lamp
START/STOP
INT. TIME
REC TIME
RM-V705U
(provided)
MENU
LCD monitor or viewfinder
Te le Macro
G ain U p
C olor F ilter
Ta pe Len gth
Ti tle
D ate /Time
Sub Menu
Main Menu Screen
Ta l ly
Inte rv al Ti me r O FF
R e c Time
J LI P I D N O.
Sub Menu Screen
RECORDING
Time-Lapse
You can record sequentially at preset time spans. Leaving
1min
the camcorder aimed at a specific subject, you can
1 s
record subtle changes over an extended period of time.
1
2
3
+
4
–
FAR
NEAR
O FF
A G C
N O R.
T 30
5
6
O N
O FF
0 7
NOTES:
Refer to pg. 35.
Advanced Features (cont.)
ENGAGE RECORD–STANDBY
MODE
Make sure the lens cover is open, then set the power
switch to "CAMERA".
SET RECORDING SPEED
Set SP/EP to SP (
pg. 13).
SET RECORDING TIME
Press REC TIME on the remote control. There are
four choices available, and they appear in the
following order (each time REC TIME is pressed):
1/4S, 1/2S, 1S, and 5S. Pressing the button again will
cancel the mode.
•You can also set the recording time in the Sub
Menu screen. Press "–" to move the highlight bar
down to "Rec Time", and press NEAR, then press +
or – to cycle through the choices.
SET INTERVAL BETWEEN
RECORDINGS
Press INT. TIME on the remote control. There are
five choices available, and they appear in the
following order (each time INT. TIME is pressed):
OFF, 15S, 30S, 1 min, and 5 min. Pressing the
button again will cancel the mode.
•You can also set the interval time in the Sub Menu
screen. Press "–" to move the highlight bar down
to "Interval Time", press NEAR, and press + or – to
cycle through the choices.
•Exposure control (
pg. 22), manual focusing
(
pg. 25) and D.I.S. settings (
be performed at this point. Once you perform step
5, these settings cannot be changed.
START TIME-LAPSE RECORDING
Press RECORDING START/STOP. Recording and
intervals alternate automatically.
RELEASE TIME-LAPSE MODE
To release when the tally lamp is not blinking,
press INT. TIME and REC TIME repeatedly until
"
" and " " disappear. To release when the tally
lamp is blinking, press RECORDING START/STOP
to stop the blinking, then press INT. TIME and REC
TIME repeatedly until "
" and " " disappear, or
set "Interval Timer" and "Rec Time" in the Sub
Menu screen to "OFF".
pg. 22) should
Hide quick links:
Table of Contents
