Fujitsu SPARC Enterprise M4000 Product Notes page 32

XCP Issues Fixed in Releases Earlier Than XCP 1091 (Continued)

TABLE 6

ID

Description

RTIF1-

Some commands that update configuration

070418-011

data take a relatively long time to execute.

RTIF1-

The fault (memory.block.ue) is encountered

070418-012

and reported periodically.

RTIF1-

When using the XSCF Web to import a

070418-020

firmware image, if the image is corrupted (for

example, if the browser window is closed

during import), the flashupdate command

might later report an internal error.

CR ID 6537996 is similar.

RTIF1-

Attempting to move a COD board using the

070418-021

moveboard(8) command might fail.

RTIF1-

The XSCF firmware monitors itself and if it

070418-022

detects any anomolies, it will force a reboot.

RTIF1-

Using the rebootxscf(8) command may

070418-023

result in a process down error, and possibly an

FMA event with MSG ID SCF-8005-NE.

RTIF1-

showaudit all shows a long list of defaults

070418-025

in the policy section after the database is

cleared.

RTIF1-

When you have updated the /etc/ttydefs

070528-001

file of Solaris to disable the console flow

control, you cannot disable the console flow

control on the telnet via a server.

RTIF1-

When connected to telnet, the login or the

070802-001

password prompt doesn't appear.

RTIF1-

Using the XSCF Web, when you selected SSH

070823-001

on the snapshot screen, the maximum number

of character input for Host, Directory, ID, and

Password doesn't correspond to the maximum

number of character input on the XSCF Shell.

22

SPARC Enterprise M4000/M5000 Servers Product Notes for XCP Version 1091 • April 2010

Workaround

Do not cancel set* commands. They appear to

hang, but eventually complete in about 30

seconds.

An uncorrectable error exists in a DIMM and

the DIMM should be replaced.

Use the command getflashimage -d to

delete the corrupted image. If necessary, reboot

the XSCF Unit, then use the flashupdate

command again to clear the internal error.

Use the deleteboard(8) and addboard(8)

commands instead of the moveboard(8)

command.

Allow the XSCF Unit to finish rebooting. It will

return to normal operation within

approximately 5 minutes.

Ignore this event.

Update the database with the following:

setaudit -a opl=enable

setaudit -a opl=default

No workaround is available.

Disconnect the telnet session and try again.

To specify the value which exceeds the

maximum number of character input for the

XSCF Web, use XSCF Shell.