Basic Mode: Network; Basic Mode: Encoder - Bosch Starlight 7000 HD Operation Manual
Mic ip starlight 7000 hd / mic ip dynamic 7000 hd series
Hide thumbs
Also See for Starlight 7000 HD:
- Installation manual (56 pages) ,
- Manual (10 pages) ,
- Quick manual (7 pages)
Table of Contents
MIC IP starlight 7000 HD, MIC IP
dynamic 7000 HD
Notice!
Ensure that recording is stopped before synching to the PC.
4
Time server IP address
The camera can receive the time signal from a time server using various time server protocols,
and then use it to set the internal clock. The unit polls the time signal automatically once every
minute.
4
Time server type
Select the protocol that is supported by the selected time server. Preferably, you should
select the SNTP server as the protocol. This supports a high level of accuracy and is required
for special applications and subsequent function extensions.
Select Time server for a time server that works with the protocol RFC 868.
14.3
Basic Mode: Network
The settings on this page are used to integrate the camera into an existing network.
Some changes only take effect after the unit is rebooted. In this case, the Set button changes
to Set and Reboot.
1.
2.
Note: If you change the IP address, subnet mask or gateway address, the camera is only
available under the new addresses after the reboot.
DHCP
If a DHCP server is employed in the network for the dynamic assignment of IP addresses, you
can activate acceptance of IP addresses automatically assigned to the camera. Certain
applications (VIDOS, Bosch Video Management Systems, Archive Player, Configuration
Manager) use the IP address for the unique assignment of the unit. If you use these
applications, the DHCP server must support the fixed assignment between IP address and
MAC address, and must be appropriately set up so that, once an IP address is assigned, it is
retained each time the system is rebooted.
IP address
Enter the desired IP address for camera in this field. The IP address must be valid for the
network.
Subnet mask
Enter the appropriate subnet mask for the selected IP address here.
Gateway address
If you want the unit to establish a connection to a remote location in a different subnet, enter
the IP address of the gateway here. Otherwise leave the box as 0.0.0.0.
14.4
Basic Mode: Encoder
Non-recording profile
You can select a profile for encoding the video signal.
You can use this to adapt the video data transmission to the operating environment (for
example, network structure, bandwidth, data load).
Bosch Security Systems
Click the Sync to PC button to copy your computer's system time to the camera.
Enter the IP address of a time server here.
Make the desired changes.
Click the Set and Reboot button. The camera reboots and the changed settings are
activated.
Operation Manual
Configuration via IP, Basic Mode | en
2014.09 | 1.3 | F.01U.291.520
43
- Quick Links:
- Configuring the Camera
Hide quick links:
Table of Contents
