EX65 Explosion-protected Camera
6.
7.
8.
10.6
Replacement of the Mounting Cradle
1.
2.
3.
4.
5.
6.
Bosch Security Systems, Inc.
Lock the back focus locking button.
Press and hold the center key for more than two (2) seconds until all menus disappear.
Close the side door panel.
Disconnect power from the EX65 and, optionally, remove all connections.
Using a 10 mm wrench or the supplied multi-use tool, remove the three (3) M6 bolts
holding the mounting cradle to the mounting surface.
Put the EX65 in a safe location.
Using a 7 mm wrench or the supplied multi-use tool, remove the seven (7) M4 bolts
holding the mounting cradle to the housing.
Install a new mounting cradle in reverse of installation and tighten the seven (7) M4 bolts
to 1.5 ft/lb (2.0 N/m).
Finish installation as described in Section 7 Mounting, page 22.
Instruction Manual
Maintenance | en
39
F.01U.412.061 | 2.0 | 2011.08