Table of Contents
Hot Gas Valve
To remove the hot gas valve:
1.
Remove the solenoid from the hot gas valve.
(See
Hot Gas Solenoid
2.
Access the sealed system and discharge the
refrigerant into an approved recovery system.
3.
Unbraze the hot gas valve from the tubing.
Caution: When installing the new hot gas valve,
use a generous amount of thermal heat trap paste
between the valve and tubing joints to protect the
valve when brazing.
Capillary Tube
Heat Exchanger
Path of warm liquid
refrigerant pushed by high-
pressure refrigerant gas
Suction
Tube
Compressor
Drier
Sealed System
.)
Evaporator
Accumulator
Condenser
Accumulating
Hot Gas
Tube
Valve
Condenser
High-Pressure
Refrigerant Gas
Warm Liquid
Refrigerant
Low-Pressure
Refrigerant Gas
Compressor
To remove the compressor:
1.
Unplug icemaker or disconnect power.
2.
Open the icemaker door.
3.
Remove the ice from the storage bin.
4.
Disconnect the water and drain lines from
the icemaker and remove the unit from its
installation.
5.
At the front and rear of the unit, remove
the 4 hex-head screws from the unit outer
compartment cover and remove the cover.
6.
To remove the terminal cover, use a fl at blade
screwdriver. Insert the screwdriver under the clip
to unsnap and remove it.
– 27 –
(Continued next page)
Hide quick links:
Table of Contents
