Connecting The Power Cord; Connecting The Ac Power Cord - HP 5500 EI Series Installation Manual

3.

Loosen the captive screws of the power supply with a Philips screwdriver until they are completely

disengaged.

4.

Grasp the handle of the power supply with one hand and pull it out a little, support the bottom with

the other hand, and pull the power supply slowly along the guide rails out of the slot.

NOTE:

Put away the removed power supply in an antistatic bag for future use.

WARNING!

Make sure the grounding cable has been correctly connected before powering on the switch.

Use

Table 5

Table 5 Power cord connection methods at a glance

Chassis

5500-24G EI (2 slots)

5500-24G EI TAA (2 slots)

5500-48G EI (2 slots)

5500-48G EI TAA (2 slots)

5500-24G SI (2 slots)

5500-48G SI (2 slots)

5500-24G-PoE+ EI (2 slots)

5500-24G-PoE+ EI TAA (2 slots)

5500-48G-PoE+ EI (2 slot)

5500-48G-PoE+ EI TAA (2 slot)

5500-24G-PoE+ SI (2 slots)

5500-48G-PoE+ SI (2 slots)

5500-24G-SFP EI (2 slots)

5500-24G-SFP EI TAA (2 slots)

1.

Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well

grounded.

2.

Connect one end of the AC power cord to the AC-input power receptacle on the switch or the

power supply (see

3.

Connect the other end of the AC power cord to the AC power outlet.

to identify the power cord connection procedures available for your switch.

Figure

17).

Connection procedure

AC-input:

Connecting the AC power cord

RPS input:

Connect the switch to a +12 VDC output RPS

AC-input:

Connecting the AC power cord

RPS input:

Connecting the switch to a –52 to –55 VDC output RPS

AC-input PSR150-A/PSR150-A1 power supply:

Connecting the AC power cord

DC-input PSR150-D/PSR150-D1 power supply:

Connecting the PSR150-D/PSR150-D1 to a –48 VDC

power source

18