Table of Contents
Push-Button Assembly
The push-button assembly is located in the front
of the visor and is held in place by a bracket
with 3 thumb screws. Access to the push-button
assembly is located behind a cover on the
underside of the visor.
To remove the push-button assembly:
1. Remove the 2 Phillips-head screws that hold the
access cover in place.
2. Loosen the 3 thumb screws on the bracket that
hold the push-button assembly in place. Do not
remove the thumb screws.
3. Remove the 2 Phillips-head screws that attach
the bracket to the visor. Remove the bracket.
Bottom View
Thumb Screws
Bracket Screws
4. Carefully lower the push-button assembly from
the visor, then disconnect the ribbon.
Push-Button Assembly
To replace the push-button assembly:
1. Connect the ribbon. Insert the push-button
assembly in the visor. Ensure that all the push
buttons protrude through the holes.
2. Place the bracket in front of the push-button
assembly. Install the 2 Phillips-head screws that
attach the bracket to the visor.
3. Tighten the 3 thumbscrews evenly. Ensure that
each of the 7 push buttons operates freely
when selected.
4. Install the access cover.
Visor
To replace the push-button ribbon:
1. Remove the visor. (See
2. Remove the push button. (See
push-button assembly.
3. Attach the end of the replacement ribbon to the
push-button ribbon, using electrical tape.
4. Pull the ribbon from the opposite end until the
replacement ribbon is visible.
Lights
Two push-in type halogen bulbs provide illumination
to the cooking surface. There are 6 lighting levels
that can be selected.
The lights are located on the underside of the
canopy.
WARNING: Before replacing a bulb, disconnect
electrical power to the hood at the main fuse or
circuit breaker panel. For your safety, do not touch
a hot bulb with bare hands or a damp cloth. The
glass cover and light bulb should be allowed to cool
completely.
Caution: Do not touch the new halogen bulb with
bare fi ngers. Touching the bulb with bare fi ngers
will signifi cantly reduce the life of the bulb. Wearing
latex gloves may offer a better grip.
Note: When replacement is necessary, use only a
new 12-volt, 20-watt halogen bulb for a G-4 base
(GE part #WB08X10045).
To remove a lightbulb, insert a small fl at-bladed
screwdriver to remove the glass cover from the
receptacle, then carefully pull the bulb out of the
socket.
Receptacle
Glass cover
ONLY use a new 12-volt, 20-watt Halogen bulb for a
G-4 base.
Receptacle
Use gloves or
cloth
– 12 –
.)
Visor
To remove the
)
Socket
Bulb
Hide quick links:
Table of Contents
