Table of Contents
Removing the Monitor from the Stand
You can remove the monitor panel from the stand to mount the panel on a wall, a swing arm, or other
mounting fixture.
CAUTION:
power and signal cables are both disconnected.
1.
Disconnect and remove the signal and power cables from the back of the monitor.
2.
Adjust the monitor height to its highest position.
3.
Press the Quick Release lever all the way to the left or right (1) then slide the monitor up and off
the stand (2).
Figure 3-22
Monitor Mounting Alternatives
The HP Quick Release can be removed from the monitor stand and installed on a mounting fixture. This
allows you to quickly and securely mount the monitor panel onto a swing arm, wall, desk or other
mounting fixture.
1.
Remove the monitor panel from the stand. Refer to
on page
2.
Remove the HP Quick Release from the monitor stand by removing the four screws that secure
the HP Quick Release to the stand.
3.
Install the HP Quick Release onto the mounting fixture or wall then slide the monitor all the way
down onto the HP Quick Release so that it clicks and locks in place.
CAUTION:
you are mounting to a wall, HP recommends that you consult with a qualified engineering,
architectural, or construction professional to determine the appropriate type and quantity of
mounting fasteners required for the application and to ensure that the mounting solution is properly
installed to support applied loads.
18
Chapter 3 Setting Up the Monitor
Before beginning to disassemble the monitor, be sure the monitor is turned off and the
Removing the Monitor from the Stand
18.
The Quick Release is designed to support a maximum of up to 24 lbs. (10.9 kg). If
Removing the Monitor from the Stand
ENWW
Hide quick links:
Table of Contents
