Software Elements; Configuration Connections; Manual Configuration - Cisco VG350 Installation Manual

Voice gateway
Table of Contents
Chapter 1
Overview of the Cisco VG350 Voice Gateway

Software Elements

The operating system for the Cisco VG350 Voice Gateway is the Cisco IOS software that resides in flash
memory.

Configuration Connections

You can use an ASCII terminal or a PC to configure a Cisco VG350 Voice Gateway. The configuration
can be performed in several ways:
Configuration Methods
Automated Configuration
If your Cisco VG350 Voice Gateway was ordered with the Simple Network-Enabled Auto-Provision
(SNAP) option, no onsite configuration is required. When the Cisco VG350 Voice Gateway is powered
on and connected, the SNAP application downloads the applicable configuration files automatically.

Manual Configuration

When a Cisco VG350 Voice Gateway is first installed, use the procedure in the
section on page 5-1
After the Cisco VG350 Voice Gateway is operating and able to communicate, use the procedures in
Cisco VG350 Voice Gateway Software Configuration Guide
functions or to make changes to the existing configuration.
There are multiple methods for configuring a Cisco VG350 Voice Gateway:
OL-25970-01
Locally, with a direct connection through the console port
Remotely, with a connection through the auxiliary port and a modem
Through Telnet and TFTP
for the initial configuration. This sets the basic communication parameters.
System configuration dialog
Configuration mode—Cisco IOS software CLI
setup command facility—Remote configuration through a LAN
SNMP-based application—CiscoView or HP OpenView
HTTP-based configuration server—Provides access to the CLI from a web browser
to configure the specific services and
Cisco VG350 Voice Gateway Hardware Installation Guide
Software Elements
"Power-On Procedure"
1-9

Hide quick links:

Table of Contents
loading

Table of Contents