Storing The Tablet Pc; Avoiding Overheating; Cleaning The Display Screen; Troubleshooting - Fujitsu Stylistic Manual
Tablet pc
Hide thumbs
Also See for Stylistic:
- User manual (30 pages) ,
- Manual (216 pages) ,
- General cleaning manuallines (3 pages)
Table of Contents
S t y l i s t i c S T 4 1 1 0 F u j i t s u Ta b l e t P C U s e r 's G u i d e - S e c t i o n O n e
5. Apply pressure to the screen protector with
your finger using a continuous wiping motion
along the edges. The adhesive sets
completely within 48 hours. To ensure a
good seal between the screen protector and
the display, do not lift the screen protector
from the display once it has been applied.
6. Remove the protective plastic cover from the
face of the screen protector, as shown in
Figure 3-3.
Figure 3-3 Installing the screen protector
7. Clean any residue left behind by the
protective coating from the exposed surface
of the screen protector by wiping gently with
a soft cotton cloth dampened with isopropyl
alcohol. Wipe the screen protector with a
soft dry cloth to remove any low-tack
adhesive; this will help prevent the pen tip
from squeaking.
The screen protector is now installed.
STORING THE TABLET PC
Store the Stylistic ST4110 Fujitsu Tablet PC in
the Off state with a fully charged battery
installed. You can store the Tablet PC in the
Off state for about 30 days with a fully charged
battery installed. After this period, the battery
should be recharged or replaced with a
charged battery.
If you intend to store the Tablet PC for a longer
period of time, the small battery that
maintains system time may need to be
replaced. Replacement of the clock battery
should only be performed by authorized
technicians.
32
AVOIDING OVERHEATING
The Tablet PC monitors its internal temperature.
As the internal temperature approaches the
tolerable limits of heat-sensitive components,
system functions are automatically limited or
turned off to prevent damage.
To avoid overheating the Tablet PC, do not
obstruct the air vents on the top and bottom
edges of the Tablet PC.
CLEANING THE DISPLAY SCREEN
To clean the Tablet PC display screen, wipe the
screen surface gently using a soft cotton cloth
slightly dampened with water or isopropyl
alcohol.
The Stylistic ST4110 Fujitsu Tablet PC is
not waterproof. Do not pour liquids on the
Tablet PC or wash the Tablet PC with a
heavily soaked cloth.
TROUBLESHOOTING
Solutions to some common problems are
described in the following sections. If you are
experiencing a problem with your Tablet PC
that you cannot solve by taking the actions
described, contact your local help desk or your
reseller for further assistance.
System Will Not Resume Operation
If the system will not resume operation after
system operation has been suspended, check
the following possible causes:
• The battery may either be defective, or
discharged to a critically low level. When the
battery reaches a critically low level, the
system is forced into Suspend-to-RAM mode
to avoid a total system power failure. To
correct this problem, either connect an
external power supply (such as the AC
adapter), or install a charged battery in the
Tablet PC.
• The system may be at the critical thermal
limit. To avoid damage to heat-sensitive
components, the system enters Suspend-to-
RAM mode when it gets too hot. System
operation cannot be resumed until the Tablet
PC cools off to a tolerable temperature.
Move the Tablet PC to a cooler location.
Hide quick links:
Table of Contents
Troubleshooting
