Table of Contents
Chapter 2 - Installing the Yamaha
CDR400c Drive
CDR400c drive settings
Before installing the CDR drive into your computer, you will need to
set the following jumpers. You set these jumpers by inserting jumper
connectors into the jumper switch located on the rear panel of the
CDR drive switch.
Important: Use long-nose pliers to remove or insert jumper connectors.
Rear Panel
Jumper Switch
Chapter 2 - Installing the Yamaha CDR400c Drive
SCSI ID settings
Parity setting
Terminator setting
Block size setting
ID SELECT
PARITY
AUDIO OUT
TERMINATOR
BLOCK SIZE
1 2 4
R G L
OUT
G L
PIN 1
PIN 2
SER. NO.
SCSI INTERFACE CONNECTOR
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
SCSI IN
PIN 11
PIN 12
DC INPUT
1
+5V G
+12V
5
- Quick Links:
- Cdr400C Features
Hide quick links:
Table of Contents
