Quick Links
MODEL
CP-SW1000H
SUBWOOFER SYSTEM
This Quick Start Guide will help you to correctly install and operate your system.
Accessories
Remote control x 1
RCA cable
(1 pin - 2 pins) x 1
(2 pins - 2 pins) x 1
Cleaning cloth x 1
Remote control battery installation
Use the "CR 2025", coin lithium battery.
1
Whilst pushing the locking tab towards the centre of
the remote control, slide out the battery holder.
2
Remove the old battery from the battery holder, insert
the new battery and then slide the battery holder back
into the remote control.
Battery holder
Polarity (+)
symbol
Battery type
Locking tab
AC power lead x 1
RCA cable
Spike x 4
Subwoofer
Foot cushion x 4
stand x 2
Back of remote control
Locking tab
Positive (+)
side up
Before using remote control
Before using remote control, please remove plastic shield
at battery holder.
Remote control
Turn on your system
1
Press the ON/STAND-BY button to turn the power on.
The volume indicator lights up blue.
(Lights
up blue)
2
To set the unit to stand-by mode:
Press the ON/STAND-BY button again.
The STAND-BY indicator lights up red.
Plastic shield
Battery holder
(Turns red)
TINSEA210AWZZ
07H R AS 1
Related Manuals for Sharp CP-SW1000H
Summary of Contents for Sharp CP-SW1000H
-
Page 1: Remote Control Battery Installation
MODEL CP-SW1000H SUBWOOFER SYSTEM This Quick Start Guide will help you to correctly install and operate your system. Accessories Before using remote control Before using remote control, please remove plastic shield at battery holder. Remote control x 1 AC power lead x 1... -
Page 2: Subwoofer Preparation
Subwoofer preparation Make sure to unplug the AC power lead before installing the main unit or changing the position. Select from three installation methods according to the preferred position. Vertical position Horizontal position Place subwoofer stand as shown Using spikes Tighten all spikes as shown Stand Using foot cushions...