Table of Contents
Available languages
Available languages
Check
Operation
[_1 Read the Dishwasher
User Instructions
that came
with your dishwasher.
[_1 Check that all parts have been installed
and no steps
were skipped.
Check that you have all tools used.
[_1 Start dishwasher
and allow it to complete
the shortest
wash cycle. After the first 2 minutes
unlatch door,
wait 5 seconds, then open door. Check that there is
water
in the bottom
of the dishwasher
tub. Check that
dishwasher
is working
properly.
If the dishwasher
is not working
properly,
disconnect
power or unplug dishwasher
and see "If Dishwasher
Does Not Operate"
section.
If Dishwasher
Does Not Operate
First try the solutions
suggested
here to possibly
avoid
the cost of a service call.
Has the circuit
breaker tripped
or the house fuse
blown?
Is the door closed tightly
and latched?
Has the cycle been set correctly
to start the
dishwasher?
Is the water turned on?
If none of these possible solutions
work, call
1-800-422-1230,
or in Canada, call 1-800-807-6777.
Additional
Tips
Expect longer wash times. Your new dishwasher
will
average 2-3 hours per load, but use nearly 40% less
energy than older models.
Designed
with a low wattage,
low energy consumption
motor, your dishwasher
washes
longer to ensure exceptional
cleaning.
Certain
models are equipped
with an optical water sensor so the
first cycle will run longer to calibrate
to optical sensor.
Selecting
certain
options could increase cycle time past
3.5 hours.
Rinse Aid is necessary
for good drying
results:
This dishwasher
is designed
to be used with rinse aid for
good drying
performance
and controlling
hard water
deposit
buildup.
Energy efficient
dishwashers
use less
water and energy, so they depend on the water sheeting
action of rinse aid for good drying
performance.
Start/Resume
light may flash:
When pressing Start/Resume,
you must make sure the
door is closed within
3 seconds.
If you do not close the
door within
3 seconds, the Start/Resume
light will flash
until you press it again. (You must also do this when
adding
a dish during the middle
of a cycle.)
NOTE: If a braided supply hose is used, replace inlet hose
after 5 years to reduce the risk of hose failure. Record
hose installation
or replacement
dates on the hose for
future
reference.
25
Hide quick links:
Table of Contents
