Step 3, Install Remote Switch - GE ZVB36 Installation Instructions Manual
Downdraft vent systems
Hide thumbs
Also See for ZVB36:
- Installation instructions manual (28 pages) ,
- Owner's manual (40 pages) ,
- Installation instructions manual (32 pages)
Table of Contents
Installation
Instructions
[-_ INSTALL REMOTE SWITCH
AWARNING:
SHOCK
HAZARD
Disconnect
electrical
power from unit before
beginning
switch installation.
Failure to do so could
result in personal injury or damage
to the electrical
controls.
WARNING: BURN HAZARD
The remote switch must be located so that it can be
operated
without
reaching over the cooktop. Failure
to do so may result in ignition of clothing which could
cause serious injury or death.
Determine
the location for the remote switch.
, The remote switch should be located so that the
vertical distance from the floor to the remote
switch is less than 48" and more than 15".
, The remote switch harness is 68" long and should
be installed so that it is not pinched and is away
from moving parts.
Connect
Remote Switch to Remote Harness
, Thread the remote harness through the 1/2"-dia.
hole and attach the harness connector
to the
remote connector.
Remove the paper backing on the remote switch
foam piece and mount the remote switch on the
countertop
such that the switch connectors
stay
located in the 1/2"-dia. hole.
, Stick adhesive wire clamp near the 1/2"-dia. hole
and attach the loose wire with a wire tie.
Strain Relief
(Adhesive wire
clamp with tie)
Control
Box
Mating Connectors
Remote Harness
Remote Switch
Foam Piece With
Adhesive Mounting"
_
Surface
_
_--
!/2"-Dia.
Hole
Strain Relief
I_-_
(Adhesive wire clamp _._
_
with tie)
_
_
_
f
If
)? -Remote
\
II
:_
Harness_
1/2"-Dia.
/ /I (
Remote
sw,tch
_,
/
F%%mtiPJgC_urV_
hAdhesive
, Drill a 1/2"-dia. hole into the desired location. Use
the mounting
bracket as a template
to locate the
hole accurately.
Check for interference
between
the switch cover, adjacent objects and cooktop/
vent overlaps.
, If switch is mounted
into a tile surface, drill the
hole between tiles. Use locally approved
caulking
to cover any gaps.
, If the remote switch is not installed on the coun-
tertop, ensure that it is installed in a location that
meets local codes and is easily accessible.
Connect Wire Lead to Control
Box
, Connect the mating wire ends.
, Place the adhesive wire clamps (provided) near
the mating connector.
, Keep approximately
Y'-Iong wire and attach
the wire to the clamp with a wire tie. This will act
as a strain relief.
12
Table of Contents
