Quick Links
YOURLIFE.OURINSPRATJON.
Dishwasher
Installation
instructions
instructions
d'instaHation du _ave-vaisse_e
Instrucciones
de insta_aci6n para _avavajiHas
Use and Care Manua_ _ocated on reverse
side
Tourner
_e guide
pour _ee instructions
d'utHisation
et d'entretien
Vo_tee e_ manua_ para encontrar
_as instruccionee
de uso y cuidado
9000089901
(8506)
Related Manuals for Bosch SHE44C07UC/22
Summary of Contents for Bosch SHE44C07UC/22
- Page 1 YOURLIFE.OURINSPRATJON. Dishwasher Installation instructions instructions d'instaHation du _ave-vaisse_e Instrucciones de insta_aci6n para _avavajiHas Use and Care Manua_ _ocated on reverse side Tourner _e guide pour _ee instructions d'utHisation et d'entretien Vo_tee e_ manua_ para encontrar _as instruccionee de uso y cuidado 9000089901 (8506)
- Page 2 Tabmeof Contents / _mportant Instructions important Safety instructions IMPORTANT The dishwasherdrain hose must be installed with a portion of it at least 20" (508mm) off the To avoid possible injury or property damage, OBSERVE ALLWARNmNGS AND CAUTmONS. cabinet floor; otherwise the dishwasher may not These instructions are intended for use by drain properly,...
-
Page 3: Tools Needed
Tooms and Matedams Needed TOOLS NEEDED Hammer Hob Saw Sbt Screwd river %20 Screwdriver Tape Measure PhHHpsScrewdriver LeveU Wire Cutter Wire Stripper DrHU MATERIALS NEEDED (AdditionaU materiab may be required to compUy with UocaU codes,) EbctrbaU SuppUyCabb ° Minimum #14 AWG, 2 conductor, 1 ground, insuUated copper conductors rated 75°C or higher, Hot Water Supply Line - Minimum 3/8"... - Page 4 Materials Supplied MATEFImALS SUPPUED Accessory Parts Supplied Accessory parts for your dishwasher come in one or more pUastb bags that are outlined bebw, NOTE: Make sure you save aH the bags until you have compbted your installation, NOTE: AUways use the supplied or recommended hardware, f Manual Set Bag A ManuaUSet Bag is provided with each dishwasher and incUudes:...
- Page 5 Enclosure Preparation 23 9/16" ',598mm) Electrical Shock Hazard To avoid electrical shock, make sure the water suppJy and ebctrical suppJy are shut off before installation or service. ENCLOSURE PREPARATmON NOTE: This dishwasher is designed to be enclosed on the top and both sides by standard residential kitchen cabinetry.
- Page 6 Emectrica{Preparation ELECTRICAL PREPARATmON ElectdcaJ Shock Hazard To avoid electrica! shock, do not work on an energized circuit. Doing so could resuJt in serious 30 _' injury or death. OnJy quaJified eJectricians shouJd (762mm) perform etectricaJ work. Do not attempt any work on the dishwasher eJectric suppJy circuit until you are certain the circuit is...
- Page 7 Plumbing Preparation PLUMBING PREPARATmON ScaJd Hazard To avoid being ecaJded, do not perform any work on a charged hot water line. Serious injury couJd reeuJt. Only quaJified plumbers ehouJd perform !4" (356mm) ptumbing work. Do not attempt any work on the Hot Water dishwasher hot water supply pJumbing until you...
- Page 8 Pmumbing Preparation/Dishwasher Preparation PLUMBING PREPARATmON (continued} Drain PJumbing Under Sink Drain Connection if the dishwasher is to drain either directUy into the househoUd drain pUumbing or through an air gap, install a Yobranch y-branch taHpbce under the sink as shown in Figure 7, Tailpiece Installing an Air Gap ff bcaU ordinances require an air gap, as shown in...
- Page 9 Dishwasher Preparation DISHWASHER PREPARATmON (continued} When any covers are removed or the dishwasher is out of the cabinet, eJectdcal power and sharp edges or points may be exposed. Removing theToe Pane1 Regular Toe Panel The toe paneUis UooseUy a ttached with tape, Remove the PaneU tape and pull the toe paneUaway from the dishwasher, Set the toe paneUaside, Ut w HU be reinstalled Uater,...
- Page 10 Door Panem_nstaHation DOOR PANEL mNSTALLATmON SH U/SH E ModeJs - Accessory Pane1 installation Hfyou have an SHU/SHE modeHand have ordered an accessory paneHkit, instaHH the paneHprior to sliding the dishwasher into pHace.The paneHdimensions are shown in Figure 16. SHi Modets - Pane! installation SHHmodeHscome with additionaH mounting hardware and a tempHate sheet with instaHHation instructions.
-
Page 11: Securing The Dishwasher
Pmacing the Dishwasher/Securing the Dishwasher PLACmNG THE DISHWASHER 1 Straighten and position the hot water supply line and the electrical supply cable as shown in Figure 19 so that they wiii align with their channels under the dishwasher base. 2 Position the dishwasherclose enough to the enclosure so that you can run the dishwasher drain hose to the under sink drain connection. - Page 12 Drain Hose Connection 2 After the unit is installed in the enciosure, ieveled and secured, Hockthe two front ieg ievelers in piace by driving the enciosed ieg ieveler Hockingscrews into each screw boss iocated in front of the ievelers, See Figure 23, 3 Tighten screws until they are flush with the surface of the bosses,...
- Page 13 Hot Water Connection HOT WAFER CONNECTmON ScaJd Hazard To avoid being scalded, do not perform any work on a charged hot water tine. Serious injury couJd result. Only quaJified pJumbere should perform plumbing work. Do not attempt any work on the dishwasher hot water supply p_umbing until you are certain the hot water euppty is shut off.
- Page 14 EmectdcalConnection ELECTRICAL CONNECTmON Strain Relief EJectrical Shock Hazard PJate To avoid electrical shock, do not work on an energized circuit. Doing so could result in serious injury or death. OnJy quatified electricians shouJd perform electrical work. Do not attempt any work on the dishwasher electric supply circuit until you...
-
Page 15: Door Tension Adjustment
ElectricamConnection/Door Tension Adjustment/Base and Toe Panem ELECTRICAL CONNECTmON (continued) Fire Hazard To avoid a fire hazard, make sure there are no toose eJectricaJ connections. Make sure aH etectricaJ connections are properly made. o Do not pre-twist the wires before connecting them with wire nuts, o Extend the dishwasher's stranded wires 1/8"... - Page 16 Base and Toe Panem/Final Instructions BASE AND TOE PANEL (Continued) PJastic Base Access Panel and'Foe Pane! installation (SHY66C, SH×99A, SHE66C, SHE99C, SH×57C, and SHV57C models onJy) 1 PUacethe PUastb Base Access PaneUunder and up the front bottom paneUof the dishwasher, as shown in Figure 34a, 2 insert the PUastb Base Access PaneUscrews into the PUastb Base Access Panel as shown in Figure 34b,...
- Page 17 Removing any cover or pulling the dishwasher from the cabinet can expose hot water connections, electrical power and If you are having a problem with your Bosch dishwasher and are not pleased with the service you have received, please take the following steps (in the order listed below) until the problem is corrected to your satisfaction,...
- Page 18 ©BSH Home Appliances Corporation 2005 , ,Litho U,S,A, 07/04 9000089901(8506)