Table of Contents
Quick Links
Operation Manual
Bedienungsanleitung
Guide de mise en oeuvre
Manuale di istruzioni
Not responsible for errors.
Losi, a Division of Horizon Hobby, Inc.
Stronghold Motorsports, Maxxis Tires, Lamb Energy, Simpson, Pro Am
Racing, Lucas Oil Products Inc., Fiberwerx Inc., K & N, Multi Mechanical
Inc., VP Racing Fuels and ReadyLift are property of their respective owners
and are used by permission or license by Horizon Hobby.
Table of Contents
Related Manuals for Team Losi Mini SCT
Summary of Contents for Team Losi Mini SCT
- Page 1 Guide de mise en oeuvre Manuale di istruzioni Not responsible for errors. Losi, a Division of Horizon Hobby, Inc. Stronghold Motorsports, Maxxis Tires, Lamb Energy, Simpson, Pro Am Racing, Lucas Oil Products Inc., Fiberwerx Inc., K & N, Multi Mechanical Inc., VP Racing Fuels and ReadyLift are property of their respective owners...
- Page 2 Introduction Thank you for choosing the Mini SCT from Losi. This guide contains the basic instructions for operating your new Mini SCT. It is critical that you read all of the instructions in order to operate your model correctly and avoid unnecessary damage.
-
Page 3: Charging Warnings And Precautions
Charging Warnings and Precautions Getting Started Failure to exercise caution while using this product and STEP 1 comply with the following warnings could result in product malfunction, electrical issues, excessive heat, FIRE, and ultimately injury and property damage. • Read all safety precautions and literature prior to use of this product. - Page 4 STEP 4 STEP 7 Install the charged battery pack into the chassis as shown. Ensure the battery is laying flat on the chassis. Once the transmitter has been powered on, turn on your STEP 5 vehicle by sliding the switch on the ESC to the “ON” position. STEP 8 Left Right...
-
Page 5: Safety Precautions
Losi Mini SCT radio system. so it is advisable to always keep some distance in all Since the Mini SCT operates on a radio signal, it is important directions around your model as a safety margin to for you to read and understand these functions before driving avoid collisions. - Page 6 Re-Binding the Transmitter THE TRANSMITTER to the Receiver The Losi DSM radio system included in the Mini SCT operates on 2.4GHz. The communication between the transmitter and receiver starts in the few seconds after the transmitter and vehicle are both turned on. This is called the “binding process”.
- Page 7 Resetting and adjusting the Battery Type Programming MSC-18BL ESC LED indicator After power is turned on, the LED will display the selected Battery Type for 2 seconds. FEATURES Red and Green LEDs are used to display selected Battery Type: Red LED Flashing = LiPo is selected Green LED Flashing = NiMH is selected To change from one battery type to another (colors described above), press the setup button during the first 2 seconds...
-
Page 8: Chassis Tuning
Although there are To track test, turn the Mini SCT on and place it on the multiple shock positions and camber link locations provided, ground. As you push it backwards allowing it to roll freely, we have built the model with the best overall settings. -
Page 9: Ride Height
Ride Height This is the height the chassis sits and runs at. Spring spacers included with the Mini SCT, when installed between the shock top and spring, will increase the pre-load on the spring and raise the chassis. You may want to try this when running on extremely rough surfaces. -
Page 10: Changing The Pinion Gear/Gear Ratio
This would be good for short layouts or when running hotter motors. The pinion on the Mini SCT offers the best balance of both. To change the pinion, remove the gear cover, loosen the motor screws, and 1. -
Page 11: Warranty Period
Steering Servo Installation/Removal (c) Purchaser Remedy- Horizon’s sole obligation hereunder shall be that Horizon will, at its option, (i) repair or (ii) replace, Unplug the servo lead from the receiver. Remove the four any Product determined by Horizon to be defective. In small screws located on the bottom of the chassis that the event of a defect, these are the Purchaser’s exclusive secure the servo to the chassis. -
Page 12: Inspection Or Repairs
INSPECTION OR REPAIRS UNITED STATES If this Product needs to be inspected or repaired, please (Electronics and engines) use the Horizon Online Repair Request submission process Horizon Service Center found on our website or call Horizon to obtain a Return 4105 Fieldstone Rd Merchandise Authorization (RMA) number. -
Page 13: Compliance Information For The European Union
Compliance Information for the European Union DECLARATION OF CONFORMITY (in accordance with ISO/IEC 17050-1) DISPOSAL OF WEEE BY USERS IN THE EUROPEAN UNION No. HH2010081901 This product must not be disposed of with other waste. Instead, Product(s): 1/16 Mini Stronghold SCT RTR it is the user’s responsibility to dispose of their waste equipment by handing it over to a designated collection point for the Item Number(s):... - Page 14 Rebuilding/Refilling the Shocks Step 5 Step 1 If you plan on completely After removing the shock, changing the shock fluid push up on the lower spring (suggested), dump out the cup and remove it from the old fluid from the shock body. shaft.
- Page 15 (LOSB9826) or 3-cell 11.1 volt LiPo battery pack (LOSB9827). Please consult the Motor/Battery Chart above for suggested motor/battery combos. The use of higher voltage battery packs will cause ESC damage and void any warranty. Consult your local hobby dealer or check www.losi.com. 15 - EN...
-
Page 16: Replacement Parts
Replacement Parts LOSB0805 Losi DSM Transmitter LOSB1212 7.2V 1100mAh NiMH Battery LOSB0813 MS20DSL Servo with Long Lead with EC2 Connector LOSB1009 Main Chassis LOSB1260 Pinion Gear Set (9T–12T) LOSB1018 Front Bulkhead, Kickplate & Brace LOSB1291 Front Shock Springs (pr) LOSB1020... - Page 17 17 - EN...
- Page 18 © 2010 Horizon Hobby, Inc. 29727.i Not responsible for typographical errors. 800-0440...