Table of Contents
Available languages
Available languages
g
Note! Do not put frozen or caramelised
1
coffee beans in the bean container. Use
only roasted coffee beans! Make sure
that no foreign objects, such as small
stones, enter the coffee bean con-
tainer. Blocking or damage caused by
foreign objects in the grinder might
be excluded from the guarantee.
The grinder is factory-set to a medium
3
grinding texture. If necessary, you can
change this setting. Notes on changing
the grinder setting can be found in
„Setting the grinding texture",
page 60.
The grinder setting may be changed
1
only while coffee is being ground.
Making adjustments to the stationary
grinder can damage the coffee
machine.
Coffee has been used to factory-test
3
the appliance, and it is therefore com-
pletely normal for there to be traces of
coffee in the mill. This appliance is
however guaranteed to be new.
5.4
Switching on for the first time
When you operate the machine for the
first time, the coffee machine has to be
vented.
0 Switch on the machine with the main
switch on the rear of the machine
(Fig. 8).
If the main switch is switched on for
the very first time, all symobls in the
display come on for a few seconds for
a check, then the symbols
are flashing.
0 Fill the water tank; see „Filling with
water", page 53.
0 Replace the water tank (Fig. 6). Press
the tank firmly in, to ensure that the
water tank valve opens.
0 Move the steam nozzle outwards and
place a cup underneath it (Fig. 9).
0 Turn the knob for steam and hot water
anticlockwise as far as it will go to the
position
(Fig. 10).
Water runs out of the steam nozzle.
The symbols
54
and
and
are on steady.
When the cup contains about 30 ml of
water, the symbols
flashing.
0 Turn the steam knob clockwise (Fig. 10)
as far as it will go, to the position
stop the water running out.
The symbol
flashes for a few seconds
and the appliance switches itself off.
0 Fill the coffee bean container with cof-
fee beans; see „Filling the coffee bean
container", page 53.
5.5
Switching on the machine
Each time before switching on, make
sure there is water in the water tank
and replenish if necessary. The machine
requires water for the automatic rins-
ing cycles that are carried out each
time the appliance is switched on or
off.
0 Switch the machine on with the "On/
Off" key
(Fig. 11).
3
Immediately after being switched on
the machine runs through a set-up
cycle. The noises occurring are per-
fectly normal.
3
During the heating-up phase (approx.
120 seconds) the symbol
During pre-heating, the appliance per-
forms an automatic rinse cycle (a little
hot water runs out of the spouts and is
collected in the drip tray beneath).
When pre-heating is complete, the
symbol
remains constantly on.
The coffee machine is now ready to
use. The symbols shown on the display
depend on the last coffee mode that
was selected.
5.6
Switching off the machine
0 Switch the machine off with the "On/
Off" key
(Fig. 11).
The symbol
flashes. The machine car-
ries out a rinsing cycle and turns off.
If the coffee machine is not used for a
3
longer period of time, it automatically
switches off for economy reasons after
3 hours.
and
start
, to
flashes.
Chapters
Table of Contents
