Mounting The Monitor - HP EliteDisplay User Manual

The monitor panel can be attached to a wall, swing arm, or other mounting fixture.

NOTE:

This apparatus is intended to be supported by UL or CSA Listed wall mount bracket.

1.

Remove the monitor panel from the stand. Refer to

CAUTION:

attach a third-party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long

screws are required. Longer screws must not be used because they may damage the monitor. It

is important to verify that the manufacturer's mounting solution is compliant with the VESA

standard and is rated to support the weight of the monitor display panel. For best performance, it

is important to use the power and video cables provided with the monitor.

2.

To attach the monitor to a swing arm, insert four 10mm screws through the holes on the swing

arm plate and into the mounting holes on the monitor.

To attach the monitor to other mounting fixtures, follow the instructions included with the

mounting fixture to ensure that the monitor is safely attached.

3.

Reconnect the cables to the monitor panel.

16

Chapter 2 Setting Up the Monitor

This monitor supports the VESA industry standard 100 mm mounting holes. To

Removing the Monitor Stand on page

15.