Table- Or Shelf-Mounting; After Installing The Switch - Cisco Catalyst 3850 Hardware Installation Manual
Catalyst 3850 series switch
Hide thumbs
Also See for Catalyst 3850:
- Hardware installation manual (146 pages) ,
- Manual (120 pages) ,
- Deployment manual (54 pages)
Table of Contents
Installing the Switch
Table- or Shelf-Mounting
To install the switch on a table or shelf, locate the adhesive strip with the rubber feet in the mounting-kit
envelope. Attach the four rubber feet to the recessed areas on the bottom of the chassis (see
Figure 2-14
1
When you complete the switch installation, see the
for more information switch configuration.
After Installing the Switch
After the switch is installed, you might need to:
•
•
•
Catalyst 3850 Switch Hardware Installation Guide
2-16
Attaching the Adhesive Pads for Table- or Shelf-Mounting
1
Adhesive pads
Configure the switch by running Express Setup to enter the initial switch configuration. For
instructions, see the switch getting started guide that shipped with the switch and also on Cisco.com.
Use the CLI setup program to enter the initial switch configuration. See
the Switch with the CLI-Based Setup Program."
Connect to the front-panel ports. See the
page 3-4
and the
"Connecting Devices to the Ethernet Ports" section on page
"After Installing the Switch" section on page 2-16
"Installing a Network Module in the Switch" section on
Chapter 2
Switch Installation
Figure
2-14).
1
Appendix C, "Configuring
2-19.
OL-26779-02
Hide quick links:
Table of Contents
