Connecting The Autodesk Control Surface - HP XW8400 Manual
With autodesk lustre 2009
Hide thumbs
Also See for HP XW8400:
- User manual (216 pages) ,
- Service and technical reference manual (210 pages) ,
- Technical reference manual (200 pages)
Table of Contents
3
Connecting System Components
Step:
3. Connect a Slave Renderer to the Lustre
workstation (Windows only).
4. Connect the workstation to video I/O
components.
5. Connect the workstation to a high-speed
data link device.
6. Connect the workstation to audio I/O
components.
Connecting the Autodesk Control Surface
The Autodesk control surface consists of three panels. You can use any combination of them. If
you are using more than one panel, you must use the network switch included with your
shipment to cross-connect them.
Refer to the Autodesk Control Surface User Guide for information on how to use the control
surface with Lustre.
N
:
The illustrations in the following procedure only show the central module, i.e. the colour
OTE
grading panel. This is the only panel that has a USB connection for the integrated tablet, and a
network port. The other two panels only have a network port, which you connect to the network
switch.
28
Refer to:
"Connecting the Slave Renderer to a Lustre
Workstation"
on page 33.
"Connecting Video I/O to a Master or HD Station"
on page 36.
"Connecting to a High-Speed Data Link Device
(HSDL)"
on page 39.
"Connecting Audio Hardware"
on page 39.
Table of Contents
