Troubleshooting Tips - GE ACSK15 Owner's Manual

Troubleshooting tips.

Savetime and money!

Possible Causes

What To Do

Heater does notstart

The heater is unplugged.

• Hake sure the heater plug is pushed completelg

into the outlet.

The fuse is blown/circuit

• Check the house fuse/circuit breaker box and replace

breaker is tripped,

the fuse or reset the breakeE

Power failure.

• If a power failure occurs, turn the heater off.

When power is restored, restart the heater.

The current interrupter

• Allow the heater to cool, press the RESET button located

device is tripped,

on the power cord plug and restart the heater`

• If the RESET button will not stag engaged, discontinue

use of the heater and contact a qualified service technician.

Heater stopped running

Power interruption or

• When the power is restored, restart the heater`

power failure occurred.

Heater knocked or tipped over.

• Seethe Tip-OverSwitch (on some models) section.

The current interrupter

• Allow the heater to cool, press the RESET button located

device is tripped,

on the power cord plug and restart the heater`

• If the RESET button will not stag engaged, discontinue

use of the heater and contact a qualified service technician.

Heater does not heat

Airflow is restricted.

• Hake sure there are no curtains, blinds or furniture

as it should

blocking the inlet or outlet of the heater. Hake sure

there is at least 3 feet (0.9m) of space on all sides of

the unit.

The temp control mag not

• In LO heat or HI heat mode, press the Increase pad.

be set correctlg.

The room mag have been cold.

• When the heater isfirst turned on, gou need to allow

time for the room to warm up.

The remote control

The batteries are inserted

• Check the position of the batteries. Theg should be

(on some models) is

incorrectlg,

inserted in the opposite (+)and (-) direction.

not working

The batteries meg be dead.

• Replace the batteries.

TIMERfeature not

A power outage or interruption

• If the Timer was set before the power outage, it will

working properly

occurred,

need to be reset after power is restored.

6