Error Code List - Mitsubishi Electric FR-A500 Instruction Manual
Transistorized inverter
Hide thumbs
Also See for FR-A500:
- Technical manual (303 pages) ,
- Instruction manual (78 pages) ,
- Instruction manual (228 pages)
Table of Contents
No.
Item
Read
Second
parameter
13
changing
(Code
Write
FF = 1)
REMARKS
Once the HFF, HEC or HF3 instruction code is written, the set value is held, but is reset to 0 when the
inverter is reset or all clear is performed.
The corresponding error code in the following list is displayed if an error is detected in any communication
request data form the computer.
Error
Item
Code
H0
Computer NAK error
H1
Parity error
H2
Sum check error
H3
Protocol error
H4
Framing error
H5
Overrun error
H6
H7
Character error
H8
H9
HA
Mode error
HB
Instruction code error
HC
Data range error
HD
HE
HF
Instruction
Code
When setting the programmed operation
H6C
(instruction code H3D to H5A, HBD to
HDA)
parameter
H00: Running frequency
H01: Time
H02: Rotation direction
HEC
When setting the bias/gain (instruction code H5E to H61, HDE to
HE1) parameter
H00: Offset/gain
H01: Analog
H02: Analog value of terminal
The number of errors consecutively detected in communication
request data from the computer is greater than allowed number of
retry times.
The parity check result does not match the specified parity.
The sum check code in the computer does not match that of the
data received by the inverter.
Data received by the inverter is in the wrong protocol, data
receive is not completed within the given time, or CR and LF are
not as set in the parameter.
The stop bit length is not as specified.
New data has been sent by the computer before the inverter
completes receiving the preceding data.
The character received is invalid (other than 0 to 9, A to F, control
code)
Parameter write was attempted in other than the computer link
operation mode or during inverter operation.
The specified command does not exist.
Invalid data has been specified for parameter write, frequency
setting, etc.
135
Description
Definition
PARAMETERS
Number of
Data Digits
6 3 3 B
Time
Minute
(Minute)
(Second)
2 digits
Inverter Operation
Brought to an alarm stop
(E.PUE) if error occurs
continuously more than
the allowable number of
retry times.
Does not accept receive
data but is not brought to
an alarm stop.
Does not accept or
receive data but is not
brought to an alarm stop.
4
Hide quick links:
Table of Contents
