Level The Range - GE C2S980 Owner's Manual And Installation Instructions
Self-cleaning dual fuel convection ranges
Hide thumbs
Also See for C2S980:
- Owner's manual and installation instructions (65 pages) ,
- Installation & owner's instructions (65 pages) ,
- Owner's manual & installation instructions (64 pages)
Table of Contents
Read these instructions
completely
and carefully.
[_
Check
Ignition
of Surface
Burners
Operation of all cooktop burners should be checked
after the range and gas supplg lines have been
carefullg checked for leaks.
Electric Ignition
Select a top burner knob and simultaneouslg
push in and turn to LITE position. You will hear
a clicking sound indicating proper operation of the
spark module. Once the air has been purged from
the supplg lines, burners should light within
4 seconds. After burner lights, rotate knob out
of the LITE position. Trg each burner in succession
until all burners have been checked.
Qualitg
of Flames
The combustion qualitg of burner flames needs
to be determined visuallg.
(AI Yellow flames-
Coil for service
(B)Yellow tips on
outer cones--
Normal for LP gas
(el Soft blue
flames--Normal
for natural gas
If burner flames looklike (A),cal! for service.Normal
burner flames should look like (B)or (C), d epending
on the tgpe of gas gou use.
With LPgas, some yellow tipping on outer cones
is normal.
_] Level the Range
F_J Install the oven shelves in the oven and
position the range where it will be installed.
Raise
range
(on some
models)
Raise
_/Lowe
r
range
range
....
/_
-_÷q'
_F
(on some models)
%
Checkfor levelnessbg placing a spirit level
or a cup, partiallg filled with water, on one
of the oven shelves.If using a spirit level,take
two readings-with the level placed diagonallg
first in one direction and then the other.
%
Removethe lower oven drawer. See the Care
and cleaning of the range section. The front
leveling legs can be adjusted from the bottom
and the rear legs can be adjusted from the top
or the bottom.
Use an open-end or adjustable wrench to
adjust the leveling legs until the range is level.
WARNING:
Never completely
remove the leveling leg as the range will not
be secured to the anti-tip device properly.
After the range is level,slide the range awag
from the wall so that the Anti-Tip device can
be installed.
51
Table of Contents
