Amana UMTK30 Installation Instructions
Amana built-in trim kit installation instructions for use with microwave ovens acm260b, umc5200ba, umc5200
Hide thumbs
Also See for UMTK30:
- Installation instructions (4 pages) ,
- Installation instructions manual (16 pages)
Quick Links
Proper installation is the installer's responsibility!
Write the model & serial numbers on the owner's
manual. The model number label is located on the
oven front.
UL Listed=For
use over electric
heat source
models
(Wall Ovens)
, UMC5200BAB/BAW/BAS
• JMC5200BAW
• AM C2206 BAB/BAW/BAQ/BAS
To avoid risk of electrical shock, personal injury, or
death, disconnect power to wall outlet before begin-
ning installation.
Parts, Tools,
and Materials
The following
parts are supplied with the oven:
Bracket
Base
Trim Frame
Bracket Left
Bracket Bottom
Bracket Top
Template
1
template
2
1" Screw
(1 required,
1 extra)
1/2" Screw
(14 required,
6 extra)
Tools required
to perform
installation:
• Phillips Screwdriver
• Saw (Electric or Hand)
• Drill with 7/64" drill bits (Electric or Hand)
• Tape Measure
• Pencil
• Framing Square
,_Level
Shipping
Weight
• Approximate shipping weight is ?? Ibs.
Cutout Dimensions
Height
16 3/4"
16 3/4"
Width
25 1/2"
25 1/2"
Depth (min.)
23 3/4"
23 3/4"
-leight
Electric Heat Source Model
To avoid risk of electrical shock, personal injury, or
Jeath:
, Before drilling into the wall, note where electrical
outlets are and where electrical wire might be
concealed behind the wall. YOU COULD GET AN
ELECTRICAL
SHOCK if you contact electrical
wire with the drill bit.
, Locate and disconnect the power to any electrical
circuits that could be affected by installing this oven.
IFYOU DO NOT DISCONNECTTHE
POWER,
IYOU COULD GET AN ELECTRICAL
SHOCK_
Electrical
rating
of this oven:
,120VAC@60Hz
• 13A/1100W
• You need a DEDICATED 120 VAC, 60 Hz, 20A,
fused electrical supply (located in the cabinet
with the microwave as close as possible to the
microwave) serving only the microwave.
• Check with a qualified electrician if you are not
sure whether the oven is properly grounded or if
you do not completely understand the grounding
instructions.
• Do not use a fuse in the neutral or grounding circuit.
)ersonal ir
,, Save these instructions for the local electrical
inspectoris use.
• If there is an electrical short circuit, grounding
reduces the risk of electrical shock by providing an
escape wire for the electric current. This appliance is
equipped with a cord having a grounding wire with a
grounding plug.
,, Place the plug into a properly installed and grounded
outlet.
• Amana does not recommend
use of an
extension
cord.
• Keep the power cord dry and do not pinch or
crush it.
• Do not, under any circumstances, remove the power
supply cord grounding prong!
• This appliance MUST be grounded!
Three-prong
(Grounding plug)
Properly polarized
grounding
outlet.
could be exposed to excessive microwave en-
Do not expose yourself to excessive
microwave
energy!
• DO NOT try to operate the microwave oven with the
door open.
• DO NOT tamper with or defeat the safety interlocks.
• DO NOT place objects between the microwave oven
front face and the door.
• DO NOT allow soil or cleaner residue to build up on
the flat surfaces around the microwave oven door.
• DO NOT operate the microwave oven if it is damaged.
• The microwave oven door must close properly to
operate safely.
• DO NOT USE THE MICROWAVE OVEN:
,, If the door is bent.
,, If the hinges or latches are broken or loose.
• If the door seals, sealing surfaces or glass is broken.
• DO NOT ATTEMPT TO ADJUST OR REPAIR THE
OVEN YOURSELF!
• It should be adjusted and repaired by a qualified
technician who can check for microwave leakage
after repairing the oven.
)ersonal in
Before you begin installingthe oven, PLACE A PIECE
OF THE CARTON OR OTHER HEAVY MATERIAL (a
blanket) over the countertop or cooktop to protect it.
Do not use a plastic cover. Failure to protect these
1
2
Related Manuals for Amana UMTK30
Summary of Contents for Amana UMTK30
- Page 1 ,, Place the plug into a properly installed and grounded -leight outlet. • Amana does not recommend extension cord. • Keep the power cord dry and do not pinch or crush it.
- Page 2 1. "SET" installment in Bracket Base 3. Fixing Remove 4 screws from the lower right and left parts Fix '1" screw' at the bottom of cabinet with use of of outer panel, place "SET" in Bracket Base and fix template 1. it by tightening 4 screws again.