Table of Contents
¢onn ctiQns
Setup
Things
to Consider
Before
You Connect
Protect Against Power Surges
•
Connect all components
before you plug any" of their power cords into the wall outlet.
•
Turn ot_"lhe TV and/or component
before you connect or disconnect
any cables.
•
Make sure all antennas
and cables are properly
grounded.
Refer to the hnportant
Safety
Instructions
on page 1.
Protect
Components
from
Overheating
•
I)on't block ventilation
holes on any of the components.
An'ange the components
so that air
can circulate freely.
•
Don't stack components.
•
If you place components
in a stand, _:qake sure you allow adequate
ventilation.
•
If you connect an audio receiver or amplifier, place it on file top shelf so file heated air from it
won't flow around other components.
Position Cables Properly to Avoid Audio Interference
•
Insert each cable firmly into the designated
jack.
•
If you place components
above the TV, route all cables down the side of the back of the TV
instead of slraight down the middle of the TV.
•
If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin
lead cables away from audio/video
cables.
Important
Stand and Base Safety Information
Choose the location for your "IV carefully. Place the TV on a stand or base that is of adequate
size
and strength to prevent the TV from being accidentally
tipped over, pushed
off, or pulled off. This
could cause personal
iniury and/or damage the TV. Ret_:r to the Important
Safety lnslructions
on
page 1.
Use Indirect Light
I)on't place the TV where sunlight or room lighting will be directed toward the screen. Use sofi or
indirect lighting.
4
Graphics contained
within lhispublication
ar_fi)r r_presentation
only.
Chapter
1
Table of Contents
