Configuring A Vmhost (Esx/Esxi Server Or Hyper V Server); First Type Of Nodes (The Vmhost Has No Dell Ulnm) - Dell PowerEdge UPS 500T User Manual
Dell ups multi-ups management console (mumc) software user's guide
Hide thumbs
Also See for PowerEdge UPS 500T:
- Installation and configuration manual (134 pages) ,
- Getting started manual (112 pages) ,
- User manual (88 pages)
Table of Contents
In this new "Virtualization" menu entry, you can Add/Edit/Remove supervisors on the right panel.
To add a new Microsoft supervisor, complete the fields below:
x
Product
x
Hostname or IP address
Click on Save after the fields are updated.
7.9. CONFIGURING A VMHOST (ESX/ESXI SERVER OR HYPER V SERVER)
Once you have entered the correct information for the supervisor (sections 7.5 or 7.6), DELL MUMC
connects to the supervisor (vCenter or SCVMM) and retrieves the VMHost information.
Dell Multi UPS Management Console then creates two different types of nodes (you can see the new
node in the Node List)
7.9.1. FIRST TYPE OF NODES (THE VMHOST HAS NO DELL ULNM)
There is no DELL UPS Local Node Manager installed on the server that is hosting the Hypervisor
(VMHost). In such case the Shutdown is remotely done by DELL MUMC. Only VMware hypervisors
are concerned by this type of shutdown.
In this case, the node has all the functionalities (remote shutdown and remote maintenance mode).
You can configure the node in the Node Configuration Panel and add a Power Source.
Dell MUMC – User Guide
P 164000119 Rev 0.03
Dell Multi UPS Management Console
The supervisor type (VMware or Microsoft)
The Supervisor Hostname or IP address.
USER GUIDE
Dell.com
42
Table of Contents
