Table of Contents
OPERATING INSTRUCTIONS
• Make sure that you have either installed the 8 "C" batteries or have
connected the unit to your household AC outlet.
• Make sure that you have removed the clear plastic battery spacer tab
from the remote control.
Setting The Clock
NOTE: The clock can only be set while the system is in the power ' Off' mode.
If the power is ' On' press the
control to shut the power ' Off' , the proceed to set the clock as follows:
1.) Press the Time/Display button once.
The display lighting turns on and the
Hour digits begin to flash.
2.) While the Hour digits are flashing
press the
(
to move the display forward or back
to the desired hour. Be sure to
observe the AM or PM indicator to
make sure you have set the hour correctly.
3.) Press the Time/Display button
again. The Hour digits stop flashing
and the Minute digits begin to flash.
4.) While the Minute digits are flashing
press the
(
to move the display forward or back
to the desired minute.
iP550_041907.p65
Power button on the main cabinet or remote
) or
(
) buttons
) or
(
) buttons
14
14
19/4/2007, 17:56
Table of Contents
