Installing The Fan Blades; Installing The Ceiling Cover - Emerson PRO CF712AB01 Owner's Manual

Pro series

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

2. Securely connect the fan motor white wire to the

supply white (neutral) wire using wire connector

supplied (Figure 10). Securely connect the fan

motor black wire and blue wire to the supply black

(hot) wire using wire connector supplied (Figure

10). After connections have been made, turn leads

upward and carefully push leads into the outlet

box, with the white and green leads on one side of

the outlet box and the black and blue leads on the

other side of the outlet box.

WIRE CONNECTOR

BLACK

SUPPLY (HOT)

BLUE

FAN WIRE

BLACK

FAN WIRE

WHITE SUPPLY

NEUTRAL)

WHITE FAN WIRE

Figure 10

WARNING

Check to see that all connections are tight, including

ground, and that no bare wire is visible at the wire

connectors, except for the ground wire. Do not

operate fan until blades are in place. Noise and fan

damage could result.

Installing The

Ceiling Cover

NOTE: When installing the ceiling fan using the

close-to-the-ceiling method, carefully lift the fan

assembly from the hook on the hanger bracket

and proceed as follows.

1. Lift the ceiling cover up to the hanger bracket.

Engage the slots in the ceiling cover with the

loosened screws in the bracket and turn the cover

counterclockwise (Figure 11). Be sure that the

lockwashers are between the screw heads and the

ceiling cover.

2. Reinstall the other two screws and lockwashers;

tighten all screws securely.

Figure 11

SUPPLY

GROUND WIRE

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the outlet box

and not pinched between the ceiling cover and the

ceiling.

GREEN GROUND

WIRE FROM HANGER

BRACKET

3. Cut the speed control switch pull chain and the

light switch pull chain to the desired lengths.

GREEN GROUND

WIRE FROM HANGER

Connect the wood pendants (supplied) to the pull

BALL

chains by sliding the pendants (small hole first)

onto the pull chains. Then attach the chain

couplings (supplied) to the end of the chains and

allow the pendants to fall down over the couplings.