Quick Links
Hitachi Plasma Display Tabletop Stand
Model
CMPAD06
Thank you for purchasing the Hitachi Plasma Display Table top Stand.
To ensure correct usage, please read this instruction manual thoroughly. After reading, please store this
manual in a safe place for future reference.
This plasma display tabletop stand is for use only with the following model:
CMP5000WX
Request an installation specialist to install this unit.
This company assumes absolutely no responsibility for injuries and damages that may occur due to improper
installation and handling.
Parts Configuration Chart
IConfirming the parts provided
Before assembly,
check to make sure that none of the parts provided are missing.
• Base cover x 1
• Screws (4 x 8) x 4
• Stand pipes
(left and right, interchangable) x 2
• Installation bolts 1
(M8 x 20) x 2
Installation Instructions
• Installation bolts 2
(M8 x 40) x 2
• Hexagonal wrench x 1
• Stabilization bolts x 2
Related Manuals for Hitachi CMPAD06
Summary of Contents for Hitachi CMPAD06
- Page 1 Model CMPAD06 Installation Instructions Thank you for purchasing the Hitachi Plasma Display Table top Stand. To ensure correct usage, please read this instruction manual thoroughly. After reading, please store this manual in a safe place for future reference. This plasma display tabletop stand is for use only with the following model: CMP5000WX Request an installation specialist to install this unit.
- Page 2 Usage cautions to ensure correct usage The following symbols are used to ensure safe usage of the product, to prevent danger Symbols to yourself and other parties and to prevent damage to property. This symbol indicates that incorrect handling due to ignoring this symbol WARNING can result in the possibility of personal injury or even death.
- Page 3 Stand assembling Screws (4 x 8) Turn the base cover over so the underside is facing up. Stand pipe Insert the stand pipes into the base cover. Use the included screws to stabilize the Screws (4 x 8) stand pipes. Stand pipe Base cover Stand attaching to the Plasma Display...
- Page 4 Stand attaching to the Plasma Display Step 2. As shown in figure, hook the stand pipe holes onto the screw heads of the installation bolts 1, then slide the stand upwards to the main plasma display until it engages the installation bolts 1 (once put together with the display, the stand will slides no more than 19 mm (3/4 inch)).
- Page 5 After assembling, connect the stand to the floor to prevent from falling over. Stabilizing to the floor Sample use of the stabilization bolts • Use screws (sold separately) to attach and stabilize the 1. Attach the stabilization bolts that come with the plasma stand.
- Page 6 Steel sheet Main material/ Surface treatment Dimensions Diagram Normal use (without optional speakers) Optional speakers attached to both sides of display 1368 Speaker 1218 Speaker Hitachi, Ltd. Tokyo Japan 292 Yohida-cho, Totsuka-ku, Yokohama, Digital Media Division (045) 866-6302 244-0817 Japan...