Server Description; Dimensions; System Chassis - HP rp7420 Service Manual
Hp 9000 rp7420 server - user service guide, fifth edition
Hide thumbs
Also See for rp7420:
- User manual (38 pages) ,
- Administrator's manual (266 pages) ,
- Manual (114 pages)
Table of Contents
Server Description
Dimensions
The dimensions of the HP 9000 rp7420 server are as follows:
•
Width: 44.45 cm (17.5 inches), constrained by EIA standard 19 inch racks
•
Depth: Defined by cable management constraints to fit into standard 36-inch deep racks
(Rittal/Compaq, Rosebowl I):
25.5 inches from front rack column to PCI connector surface
26.7 inches from front rack column to MP Core I/O connector surface
30 inches overall package dimension, including 2.7 inches protruding in front of the front
rack columns
•
Height: 10U – 0.54 cm = 43.91 cm (17.287 inches). This is the appropriate height for a product
that consumes 10U of rack height while allowing adequate clearance between products
directly above and below this product. Fitting four server units per 2 m rack and upgrade
of current 10U height products in the future are the main height constraints.
System Chassis
The mass storage section located in the front enables access to removable mass storage devices
without removal of the bezel (not shown). This is especially helpful when the system is mounted
in the lowest position in a rack. The mass storage bay accommodates one 5.25-inch removable
media device and up to four 3.5-inch hard drives. The front panel display board, containing
LEDs and the system power switch, is located directly above the 5.25-inch removable media bay.
Below the mass storage section and behind a removable bezel are two PCI DC-to-DC power
converters.
The BPS section is partitioned by a sealed metallic enclosure located in the bottom of the package.
This enclosure houses the N+1 fully redundant BPS.
28
Overview
Hide quick links:
Table of Contents
