Managing And Configuring The Router To Run Using Consolidated Packages And Individual Subpackages; Quick Start Software Upgrade - Cisco ASR1002 - ASR 1002 Router Software Configuration Manual
Asr 1000 series aggregation services routers
Hide thumbs
Also See for ASR1002 - ASR 1002 Router:
- Quick start manual (47 pages) ,
- Installation manual (46 pages) ,
- Configuration manual (34 pages)
Table of Contents
Managing and Configuring the Router to Run Using Consolidated Packages and Individual SubPackages
The following example shows a confirm prompt notification:
The system is without a fully initialized peer and service impact will occur. Proceed with
abort? [confirm]
The issu runversion command is optional for completing a consolidated package upgrade on the
Cisco ASR 1000 Series Routers. You can enter issu commitversion from the active RP to complete the
software upgrade, then use the redundancy force-switchover command to switch to the upgraded RP
on this platform, if desired.
Note
For additional information on limited downtime upgrades using the issu command set, see the
Upgrade Process" section on page
Managing and Configuring the Router to Run Using Consolidated
Packages and Individual SubPackages
This section discusses the following topics:
•
•
•
•
•
Quick Start Software Upgrade
The following instructions provide a quick start version of upgrading the software running the Cisco
ASR 1000 Series Routers. These instructions assume you have access to the consolidated package and
that the files will be stored in a bootflash: file system that is not storing any previously installed
subpackages or consolidated packages and that has enough room for the file or files.
For more detailed installation examples, see the other sections of this chapter.
To upgrade the software using a quick start version, perform the following steps:
Step 1
Copy the consolidated package into bootflash: using the copy URL-to-image bootflash: command.
If you want to run the router using individual subpackages, enter the request platform software
Step 2
package expand file bootflash:image-name command. If you want to run the router using a
consolidated package, skip this step.
Enter the dir bootflash: command to verify your consolidated package or your extracted subpackages
Step 3
are in the directory.
If you are trying to run individual subpackages, use the delete bootdisk:image-name to delete the
Step 4
consolidated package. If you want to run the router using the consolidated package, skip this step.
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
6
Quick Start Software Upgrade, page 6
Managing and Configuring a Router to Run Using a Consolidated Package, page 7
Managing and Configuring a Router to Run Using Individual SubPackages From a Consolidated
Package, page 10
Managing and Configuring a Router to Run Using Optional SubPackages, page 14
Troubleshooting Software Mismatch with ESP Board ASR1000-ESP10-N, page 18
Consolidated Packages and SubPackages Management
1.
"Software
Table of Contents
Troubleshooting
