Main Memory - HP Kayak XW A2-U2-W2 Handbook
Pc workstation
Hide thumbs
Also See for Kayak XW A2-U2-W2:
- User manual (154 pages) ,
- Troubleshooting manual (21 pages) ,
- Manual (17 pages)
Table of Contents
HP Kayak XU (up to 333 MHz) & HP Kayak XW Series A2, U2, W2
Main Memory
The PC Workstation has four DIMM slots on the system board for installing
main memory; slots A, B, C and D.
Models are supplied with 32, 64 or 128 MB of main memory. If additional
memory is required, up to 512 MB may be installed. Memory upgrades are
available in single 32 MB, 64 MB or 128 MB ECC SDRAM modules. A serial
EEPROM on the DIMM contains data on the memory speed. This information is
read at each power on, and access time settings are set accordingly.
Millennium II Video Memory (HP Kayak XU)
There is 4 MB of video memory already supplied on the graphics controller
4
board. Memory may be upgraded to a maximum of 16 MB by installing a
memory module of 4 MB, 8 MB or 12 MB onto the board. No switch or jumper
settings need to be changed (all jumpers should be left in the positions in which
they were set by the manufacturer).
AccelEclipse Video Memory (HP Kayak XW Series U2)
There is a total of 32 MB of memory, already supplied on the graphics controller
board. There are no upgrades possible, and no switch or jumper settings to be
changed (all jumpers should be left in the positions in which they were set by
the manufacturer).
In case of failure, the whole video board has to be replaced. The replacement
video board is supplied with 32 MB of memory.
PCI bus connector
Cooling fan
Daughter board
Mini-Tower
HP Kayak XU (up to 333 MHz) & HP Kayak XW
PC Workstations
Series A2, U2, W2 4-9
Hide quick links:
Table of Contents
