Statstest - HP StorageWorks 2/64 - Core Switch Command Reference Manual
Hp storageworks fabric os 5.x command reference guide (aa-rvhvb-te, september 2005)
Hide thumbs
Also See for StorageWorks 2/64 - Core Switch:
- Reference manual (278 pages) ,
- Installation manual (166 pages) ,
- Administrator's manual (152 pages)
Table of Contents
statsTest
Runs a statistics counter diagnostic test.
Synopsis
statstest [-passcnt count][-ports itemlist]
Availability
admin
Description
Use this command to verify the ASIC statistics counter logic. It can run on every base port of the quadrant,
and send the frame through internal loopback with no CRC data to induce the CRC error. This command
is also run from camTest.
This test covers the following statistics counter functionality:
•
The number of received frames with CRC errors that matched the SID-DID pair specified in the LINK
table. There are 16 of these statistics counters (0-15).
•
The number of received words in frames that matched the SID-DID pair specified in the LINK table.
There are 16 of these statistics counters (0-15).
•
The number of transmitted words in frames that matched the SID-DID pair specified in the LINK table.
There are 16 of these statistics counters (0-15).
•
The number of frames with CRC error that matched the corresponding ALI (0-127), respectively.
This command cannot be executed on an operational switch. You must first disable the switch using the
switchDisable
NOTE:
There is a link table that stores 16 pairs of SID-DID address. Each of the SID-DID pairs is named
a link. This table is used for gathering statistics that match the link.
This command is not supported on HP StorageWorks 4/8, 4/16, or 4/32 SAN switches and 4/256
SAN Director; use miniCycle or portLoopbackTest instead.
Operands
This command has the following optional operands:
-passcnt count
-ports itemlist
Examples
To run a statistics counter test on a switch:
switch:admin> statstest -passcnt 1 -ports 1/0-15
Running Statistics Counter Test ....... passed.
666 Fabric OS commands
command.
Specify the number of times to perform this test. The default value
is 1.
Specify a list of user ports to run the test. If omitted, all the user
ports in the switch are assumed. See
information about selecting ports.
for more
itemList
Table of Contents
