Warnings and cautions WARNING! Any surface or area of the equipment marked with this symbol indicates the presence of an electrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed area marked with this symbol. WARNING! To reduce the risk of electric shock or damage to your equipment: —...
Step 1—Preparing for component installation NOTE: Workstation models vary. All illustrations are examples only. Accessing the internal components of the workstation If you need help preparing the workstation for this installation, consult the removal and replacement procedures in the service guide for your workstation at http://www.hp.com/support/ workstation_manuals.
Step 2—Installing and connecting the eSATA adapter NOTE: To locate the appropriate connectors on the system board, see the service label on the workstation access panel. Insert the eSATA adapter into the selected slot with the two SATA connector cables protruding inside the workstation chassis Close the expansion slot retention clamp Figure 2...
Page 5
Step 5—Setting the system BIOS for eSATA operation Workstations To access the Computer Setup (F10) Utility menu: Power on or restart the workstation. As soon as your display is active and F10=Setup appears in the lower right corner of the screen, press F10.
HP xw Workstations To access the Computer Setup (F10) Utility menu: Power up the workstation. Press as soon as your display is active and you see F10=Setup appear in the lower-right corner of the screen. NOTE: If you do not press at the appropriate time, turn the workstation off, turn it on, and then press again to access the utility.