HP Workstation xw4000 Series Hardware Installation
Rack mount tray installation
Hide thumbs
Also See for Workstation xw4000 Series:
- Hardware reference manual (64 pages) ,
- Getting started (22 pages) ,
- Hardware installation (5 pages)
Quick Links
See also:
Troubleshooting Manual, Service Reference Manual
Rack mount tray installation
Introduction
This document describes how to install the HP Z200, Z400 and xw4000 Workstation series into a rack
mount tray. It also describes how to mount the workstation-tray assembly into a rack.
Kit contents
●
Rack mount tray
●
Adapter brackets
●
Rails and mounting hardware
●
Installation instructions (this document)
●
Warranty information
Required tools
●
T-15 Torx screwdriver
●
T-20 Torx screwdriver
●
Cross-tip screwdriver
ENWW
© 2010 Hewlett-Packard Development Company, L.P. Printed in the U.S.
Introduction
1
Related Manuals for HP Workstation xw4000 Series
Summary of Contents for HP Workstation xw4000 Series
-
Page 1: Kit Contents
Adapter brackets ● Rails and mounting hardware ● Installation instructions (this document) ● Warranty information Required tools ● T-15 Torx screwdriver ● T-20 Torx screwdriver ● Cross-tip screwdriver © 2010 Hewlett-Packard Development Company, L.P. Printed in the U.S. ENWW Introduction... -
Page 2: Warnings And Cautions
Warnings and cautions WARNING! Any surface or area of the equipment marked with this symbol indicates the presence of an electrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed area marked with this symbol. WARNING! To reduce the risk of electric shock or damage to your equipment: —... -
Page 3: Step 1-Preparing The Workstation
Step 1—Preparing the workstation NOTE: All illustrations are examples only. Workstation models vary. For product-specific information, see the service guide for your HP workstation at http://www.hp.com/support/manuals before beginning installation. To prepare the workstation for component installation: Power down the workstation, and then disconnect the power cord. Power down all external devices, and then disconnect them from the workstation. - Page 4 To prepare the tray: Select the adapter bracket with the label that matches your workstation model. To install the adapter bracket onto the tray, fit the tab (1) on the adapter bracket into the locking hole on the tray, and then secure the two black captive screws (2). Loosen the black rear captive screw (3).
- Page 5 Step 4—Loading the workstation-tray assembly into the rack To load the assembly into the rack: Place the rear of the workstation-tray assembly on the rail-bracket shelf (1). Ensuring that the rail-bracket shelf (2) is engaged by the lip on the underside of the tray (3), slide the assembly into position in the rack.
-
Page 6: Step 5-Completing Installation
Secure the assembly into the rack by tightening the silver captive screws (1). Figure 6 Completing installation NOTE: To remove the assembly from the rack, loosen the silver captive screws (1), and then pull the handle to slide the assembly out of the rack until the latches in the tray (2) engage the stop feature.