Table of Contents
Chapter 21
Configuring Multiprotocol Label Switching
•
To see detailed information about each VC, add the keyword detail.
Configuring Port-Based EoMPLS
When configuring port-based EoMPLS, follow these guidelines and restrictions:
•
•
•
OL-11439-03
Next Hop—IP address of neighbor that assigned the outgoing label.
–
To view the state of the currently routed VCs, enter the show mpls l2transport vc command.
Router# show mpls l2transport vc
Local intf
Local circuit
-------------
-------------------- --------------- ---------- ----------
Vl2
Eth VLAN 2
Vl3
Eth VLAN 3
Router# show mpls l2transport vc detail
Local interface: Vl2 up, line protocol up, Eth VLAN 2 up
Destination address: 11.11.11.11, VC ID: 2, VC status: up
Tunnel label: 17, next hop 34.0.0.2
Output interface: GE3/3, imposed label stack {17 18}
Create time: 01:24:44, last status change time: 00:10:55
Signaling protocol: LDP, peer 11.11.11.11:0 up
MPLS VC labels: local 20, remote 18
Group ID: local 71, remote 89
MTU: local 1500, remote 1500
Remote interface description:
Sequencing: receive disabled, send disabled
VC statistics:
packet totals: receive 1009, send 1019
byte totals:
receive 133093, send 138089
packet drops:
receive 0, send 0
Local interface: Vl3 up, line protocol up, Eth VLAN 3 up
Destination address: 11.11.11.11, VC ID: 3, VC status: up
Tunnel label: 17, next hop 34.0.0.2
Output interface: GE3/3, imposed label stack {17 19}
Create time: 01:24:38, last status change time: 00:10:55
Signaling protocol: LDP, peer 11.11.11.11:0 up
MPLS VC labels: local 21, remote 19
Group ID: local 72, remote 90
MTU: local 1500, remote 1500
Remote interface description:
Sequencing: receive disabled, send disabled
VC statistics:
packet totals: receive 1406, send 1414
byte totals:
receive 185497, send 191917
packet drops:
receive 0, send 0
The AToM control word is not supported.
Ethernet packets with hardware-level cyclic redundancy check (CRC) errors, framing errors, and
runt packets are discarded on input.
Port-based EoMPLS and VLAN-based EoMPLS are mutually exclusive. If you enable a main
interface for port-to-port transport, you also cannot enter commands on a subinterface.
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
Dest address
VC ID
11.11.11.11
2
11.11.11.11
3
Any Transport over MPLS
Status
UP
UP
21-19
- Quick Links:
- Product Overview
Hide quick links:
Table of Contents
Related Manuals for Cisco WS-SUP32-GE-3B - Supervisor Engine 32
Related Products for Cisco WS-SUP32-GE-3B - Supervisor Engine 32
- Cisco WAN Modeling Tools
- Cisco WS-SUP720-3B - Supervisor Engine 720
- Cisco WS-SVC-AGM-1-K9= - Anomaly Guard Module
- Cisco WS-SVC-CMM-ACT-RF - Conferencing And Transcoding Port Adapter Voice DSP Module
- Cisco WS-SVC-ADM-1-K9= - Traffic Anomaly Detector Module
- Cisco WS-SVC-FWM-1-K9= - Firewall Service Module
- Cisco WS-SVC-IDS2-BUN-K9 - Intrusion Detection Sys Module 2
- Cisco WS-SVC-IPSEC-1= - IPSec VPN Services Module