Step 6: Install 90° Elbow; Step 7: Install Drain Hose To Drain Loop; Step 8: Position Water Line And House Wiring - GE GDT550HSDSS Installation Instructions Manual
Built-in dishwasher
Hide thumbs
Also See for GDT550HSDSS:
- Owner's manual (48 pages) ,
- Dimensions and installation information (2 pages) ,
- Manual (119 pages)
Table of Contents
Available languages
Available languages
Dishwasher Installation
STEP 6: INSTALL 90° ELBOW
thread seal tape.
onto the water valve.
elbow. Water valve
bracket could
bend or water valve
fitting could break.
Thread
Seal
the elbow to face the
Tape
rear of the dishwasher.
STEP 7: INSTALL DRAIN HOSE TO DRAIN
LOOP
Connect drain loop end to drain hose using the screw clamp
as shown in the figure.
Figure L
Front of Dishwasher
Bracket
90° Elbow
Fill Hose
Figure K
STEP 8: POSITION WATER LINE
AND HOUSE WIRING
the opening to avoid interference with base of dishwasher
and components under dishwasher.
4"
6"
Water
Line
Figure M
STEP 9: INSTALL DRAIN HOSE,
THROUGH CABINET
hose into the hole in cabinet side. If a power cord is used,
guide the end through a separate hole.
Insulation
Blanket
Figure N
noise concerns.
Position utility lines so they do not interfere with anything
under or behind the dishwasher.
4"
6"
House
Wiring
Maximum Drain Hose
Length 10'
Water
Line
Drain
Hose
House
Wiring
Power Cord
(If Used)
7
Hide quick links:
Table of Contents
