Setting The Ip Address; Setting The Default Account Passwords; Maximum Number Of Simultaneous Sessions - HP A7533A - Brocade 4Gb SAN Switch Base User Manual
Hp storageworks fabric os 5.x procedures user guide (aa-rvhwb-te, september 2005)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Administrator's manual (576 pages) ,
- Hardware reference manual (256 pages) ,
- Release note (76 pages)
Table of Contents
2.
Open a terminal emulator application (such as HyperTerminal on a PC, or TERM, TIP, or Kermit in a
UNIX® environment), and configure the application as follows:
• In a Windows® environment:
Parameter
Bits per second
Databits
Parity
Stop bits
Flow control
• In a UNIX environment, enter the following string at the prompt:
tip /dev/ttyb -9600
If ttyb is already in use, you can use ttya (enter tip /dev/ttya -9600).
3.
Observe the following considerations for serial connections:
• Some procedures require that you connect through the serial port, for example, setting the IP
address or setting the boot PROM password.
• If secure mode is enabled, connect through the serial port of the primary FCS switch.
• For the Core Switch 2/64, SAN Director 2/128, and 4/256 SAN Director, you can connect to
CP0 or CP1 using either of the two serial ports.
Setting the IP address
You must connect through the serial port to set the IP address (see
page 21). After connecting, issue the ipAddrSet command to set the IP address.
CAUTION:
The use of IP address 0.0.0.0 is not supported. Do not use this address.
Fabric OS versions beginning with 2.6.0, 3.1.0, and 4.0.0 support Classless Inter-Domain
Routing (CIDR).
Setting the default account passwords
For each logical switch (domain), there are admin and user default access accounts. These accounts
designate the following levels of authorization—called roles—for using the system:
•
Admin level for administrative use
•
User level for non-administrative use, such as monitoring system activity
•
SwitchAdmin level for administrative use, except for security, user management, and zoning
Two accounts—factory and root—are reserved for development and manufacturing. You can change their
passwords, which is optional, but do not use these accounts under normal circumstances.
Table 2
shows the number of simultaneous login sessions allowed for each role.
Table 2
Maximum number of simultaneous sessions
User name
admin
user
For the 4/8 SAN Switch, 4/16 SAN Switch, SAN Switch 2/8V, SAN Switch 2/16V, SAN Switch 2/32,
Brocade 4Gb SAN Switch for HP p-Class BladeSystem, SAN Switch 4/32, SAN Director 2/128, and the
4/256 SAN Director (default configuration with one domain), there is one set of default access accounts.
22
Performing basic configuration tasks
Value
9600
8
None
1
None
Maximum sessions
2
4
"Connecting through the serial
port" on
Table of Contents
Troubleshooting
