HP A3724A - SureStore E Hub S10 Installation Manual

Plenum shroud

PDU cable

Select a secure location in the rack. The FC-AL hub requires only one EIA of rack space. Remove filler panels as needed

and mount the hub as follows:

Step 1:

Unpack the rackmount kit.

Unpack the rackmount kit and check the contents

for the parts shown in Figure 1. If parts are

missing, contact an HP sales representative.

Step 2:

Prepare the hub for mounting.

• For a new hub, unpack the hub and discard the

rubber feet from hub contents.

• For a hub that has been used as a standalone:

1. Move the hub to its new location and peel

off the rubber feet attached to the bottom of

the hub.

2. Replace missing mounting ear brackets.

Attach the brackets to the outside front

corners of the hub using three M3x.5 screws

for each and turning the angled end of the

bracket outward. See Figure 2.

3. Replace missing nylon retainers on the left

and right sides of the hub. Insert one M3x.5

FC-AL Hub Rackmount Kit

Rails

Figure 1

Nylon

retainers

M3x.5

screws

Mounting

ear brackets

screw through the center of the retainer and

into the hole on each side of the hub. See

Figure 2.

• For a new or existing hub, record the MAC

address located below the 10Base-T port on the

hub. This unique address identifies the hub.

Figure 2

FC-AL Hub Rackmount

Kit Installation Guide

10-32x.625

screws

Sheet metal

nuts